Porsche carrera GT
Discussion
Clutch kit is £7k IIRC and circa £3.5k labour at Reading! It's not too bad to use, gets a lot easier with practice but if your concentration lapses and you dab the throttle (insted of letting the ECU dial in your revs) it's quite easy to stall!! You can get the clutch thickness measured by dropping the rear undertray, nominal wear is around 32-33mm (I think)
Good luck, it's an incredible car!!
Good luck, it's an incredible car!!

Clutch is easy to use,if you are used to a racing clutch,as said take time and let the ecu do the pulling away.
Clutch has been lasting between 7 ,ooomiles to 20,000 so far or as little as 6 miles being loaded onto a recovery truck!
RS Tuning have a alternative clutch in the pipeline as do others,also labour not so expensive as Reading with Porsche specialists now starting to work on these cars.
The clutch is fine and the least of your worries if considering a GT,enjoy the driving of them as the rs is not in the same game.
Clutch has been lasting between 7 ,ooomiles to 20,000 so far or as little as 6 miles being loaded onto a recovery truck!
RS Tuning have a alternative clutch in the pipeline as do others,also labour not so expensive as Reading with Porsche specialists now starting to work on these cars.
The clutch is fine and the least of your worries if considering a GT,enjoy the driving of them as the rs is not in the same game.
Ditto to the above.
Using the approved method of letting the clutch out in a slow and controlled manner to allow the ECU to get the car moving at idle BEFORE you give it any throttle works fine and only catches you out occasionally once you are used to it - clutch actuation is not hydraulic which I guess helps in "feeling" the bite point but is a hinderance for those of us with chicken legs
Once on the move the clutch is awesome - no issues and lightening shifts are simple.
Edit: Clutch actuation is actually hydraulic (just doesn't feel like it !)
Using the approved method of letting the clutch out in a slow and controlled manner to allow the ECU to get the car moving at idle BEFORE you give it any throttle works fine and only catches you out occasionally once you are used to it - clutch actuation is not hydraulic which I guess helps in "feeling" the bite point but is a hinderance for those of us with chicken legs

Once on the move the clutch is awesome - no issues and lightening shifts are simple.
Edit: Clutch actuation is actually hydraulic (just doesn't feel like it !)
Edited by TB993tt on Tuesday 23 October 08:40
Scotty_917 said:
That's correct....seen him a number of times near St Albans...
Ah, I've seen that one too - on way back from Watford Junction to WGC via London Colony, iirc? They were certainly some narrow and craggy roads!Looked stunning. First and only time I've seen one on the road.
spenny_b said:
Scotty_917 said:
That's correct....seen him a number of times near St Albans...
Ah, I've seen that one too...via London Colney....Looked stunning. First and only time I've seen one on the road.
When I lived in Hertford a few years ago my next door neighbour had a silver one....but only ever saw that going on or off a low loader.....revving it at idle also raised the 'ole hairs on the back of the neck...

Gassing Station | Porsche General | Top of Page | What's New | My Stuff




