964 DRIVE QUALITY
Discussion
I test drove a 964 today with sports cat, cup pipe, 100mm tail pipe and KN cup style filter,the car felt rough,and a bit clattery...Is this to be expected, compared to standard
Also how restrictive is a sports cat compared to a bypass, is a bypass louder.
Steering also felt a bit loose...
Also how restrictive is a sports cat compared to a bypass, is a bypass louder.
Steering also felt a bit loose...
W A L K A W A Y.
Should feel tight, nimble, smooth, then as you start to hustle it should feel as if it just wants to turn in and in.
Should be no rattles (the odd vibration from trim is to be expected) no nasty noises.
I don't think there is much difference between standard cat, sports cat or bypass in terms of noise or power.
Should feel tight, nimble, smooth, then as you start to hustle it should feel as if it just wants to turn in and in.
Should be no rattles (the odd vibration from trim is to be expected) no nasty noises.
I don't think there is much difference between standard cat, sports cat or bypass in terms of noise or power.
Steering should be tight, engines can be clattery, they are oil cooled after all.....but they shouldn't be loudly so.
Cat Bypass is ever-so-slightly louder than sports cat, but you'd be hard pushed to notice......bypass and sports Exhaust normally pushes out 104-106dB.....so not good for the track, my Gpipe was 104.5...
They are pretty nimble things.......Best to walk by the sounds of it.
Kevin
Cat Bypass is ever-so-slightly louder than sports cat, but you'd be hard pushed to notice......bypass and sports Exhaust normally pushes out 104-106dB.....so not good for the track, my Gpipe was 104.5...
They are pretty nimble things.......Best to walk by the sounds of it.
Kevin
Actually I have found a lot of 964's that sound as if they have a chain on the way, or a really bad tappet and it turned out to be the exhaust. Worst is if a heat exchanger goes.
So yes it could be the problem, simple to check, gun gum up the hole and see if it goes away, if it does get the silencer welded or replaced. They do weld very well.
So yes it could be the problem, simple to check, gun gum up the hole and see if it goes away, if it does get the silencer welded or replaced. They do weld very well.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff



