964; Selecting first gear
964; Selecting first gear
Author
Discussion

f@tboy

Original Poster:

421 posts

230 months

Tuesday 30th October 2007
quotequote all
On a c2 964 with a fairly recent clutch, if first gear is a bit reluctant to go in, when stationary and at walking pace, what would your thoughts be?

"They often do that - you just tighten up the widget in the linkage and it'll be fine"

or

"964 linkages are bombproof; so it must be the gearbox" or similar

or...???

robmug

1,047 posts

294 months

Tuesday 30th October 2007
quotequote all
Not right; should engage 1st easily. No idea how easy to fix though.

They can be stiffer to change when the gearbox oil is cold though.

wildoliver

9,325 posts

247 months

Tuesday 30th October 2007
quotequote all
Agreed should be smooth, normal to be notchy at cold, but 5 miles and should be nice and smooth, won't say like silk as the gearchange isn't the smoothest but it should feel nice.

Henry-F

4,791 posts

276 months

Tuesday 30th October 2007
quotequote all
The easiest way to see if it`s the clutch at fault:

Car stationary foot off clutch, press clutch & try to engage 1st gear. If it doesn`t want to go in keep the pressure on the gear lever and turn the engine off. If the gear lever drops into gear it is the clutch (which isn`t disengaging properly and dragging the input shaft of the gearbox round).

If the lever still doesn`t want to go into gear with the engine off then it won`t be the clutch.

A bit over simplified but it gives you something to work with.

Henry smile

lanesra10

314 posts

262 months

Tuesday 30th October 2007
quotequote all
Before trying any expensive remedies make sure the gearbox oil is changed, its an area that is neglected when the car is serviced, you could just be short of oil or the oil's degraded, usually shows up as a gear selection problem.

oldtimer

300 posts

287 months

Tuesday 30th October 2007
quotequote all
On a 964 C2 the clutch slave cylinder is mounted in a fairly inaccesssible spot over gearbox and rarely if ever gets bled , this can lead to problems selecting first when car is hot. Cure is to do thorough bleed out and check clarity of fluid collected , till it runs clear. Otherwise try replacing clutch slave cylinder.

nine6four

313 posts

241 months

Tuesday 30th October 2007
quotequote all
Also check the clutch pin. Mind had a similar sounding problem which was cured for 50p. That was after the AA unsuccessfully bled the system in a car park in Devon and therefore had to tow me 200 miles to my specialist. Grrr.

Edited by nine6four on Tuesday 30th October 22:14