Suspension Brushes??
Discussion
JD, I'm afraid they're probably right. It's one of those common problems on the Boxters and 996s (don't know about 997s). The lower arm bushes wear and the only remedy is to replace the arms, as the bushes are not replaceable. They are about 190 pounds each, plus fitting of course.
I was advised to change them by my OPC but they aren't noisy yet and they have to be really bad to fail an MOT, so mine will wait a little while. If the tyre wear is normal, then the geometry is okay and the bushes are probably not too bad.
There are some other noisy bits of suspension, the anti-roll bar drop link and the strut top bushes wear as well. These are cheaper to put right, make sure you repair the right bits!
Good luck
Orangeboy.
I was advised to change them by my OPC but they aren't noisy yet and they have to be really bad to fail an MOT, so mine will wait a little while. If the tyre wear is normal, then the geometry is okay and the bushes are probably not too bad.
There are some other noisy bits of suspension, the anti-roll bar drop link and the strut top bushes wear as well. These are cheaper to put right, make sure you repair the right bits!
Good luck
Orangeboy.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


