Tuscan 2 indicater problem

[Jeff J]

Hi All, I have a problem with the right turn indicator, left turn and hazards work ok so I assume it's the switch.This set up is new to me as the indicator stalk is on the drivers side. Someone mentioned it could be a micro switch, I've searched for for an indicator micro switch but unable to locate any, any help much appreciated.

[Andrew H.]

Hello Jeff

May be?? it's the pcb located as described below - an old post of mine from May 2006
"Sorted - there is a small PCB (called an "indicator failure detection unit" ) located in the drivers side door pillar - remove the speaker panel to gain access. The PCB is wrapped in insulation tape which had helped to retain water / condensation? causing the PCB to corrode - common problem apparently. The replacement part cost £35. Forget the insulation tape."

Andrew

[Jeff J]

Hi Andrew, thanks for that.
The reason I thought it was the switch was because, before it finally stopped working, I could get it to work by pressing the stalk all the way through it's travel whereas the left turn only required slight movement of the stalk.
Did you have the same problem as I'm having here, and you traced it down to this PCB?
Do you know who could supply this part?
Thanks Jeff