cigarette lighter socket removal
Discussion
Nah you can do it easily without taking the console off, the centre will just screw out, this leaves the rear socket section under the console. You can get to this by taking the ash tray out. If you have massive hands just pop the alloy trim out that holds the ashtray, its knurlled and is a tight fit but will pop out with abit of a wiggle.
Before you rip it out, mine would not power anything up but the fuse was ok, i checked the voltage and it was onlt 3v, took the fuse out and it was alittle corroded, gave it a clean up with some wet and dry, popped it back in and all is well again.
Before you rip it out, mine would not power anything up but the fuse was ok, i checked the voltage and it was onlt 3v, took the fuse out and it was alittle corroded, gave it a clean up with some wet and dry, popped it back in and all is well again.
There are some spade connectors on teh back of teh socket - mine have fallen off before.
If you do take the console off (easy) remember to line up and connect the rear vent pipe with the vent - its a pretty poor design and its easy to have all the hot air blowing around under the console!
If you do take the console off (easy) remember to line up and connect the rear vent pipe with the vent - its a pretty poor design and its easy to have all the hot air blowing around under the console!
Gassing Station | Tuscan | Top of Page | What's New | My Stuff



