new outriggers
new outriggers
Author
Discussion

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
.
.

Ah the great british craftsmen,s work;)

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
by the way this is the better of the two sides rolleyes

scotty_d

6,795 posts

223 months

Monday 9th April 2012
quotequote all
Ouch hope they did not charge you top $ for that.

I am going to have mine done soonish. I am going up to TVR ecosse to have mine done as there is not much left of the near side one.

grngriff

187 posts

185 months

Monday 9th April 2012
quotequote all
For the money they charge I would expect better workmanship !
Mine due this year,I'd better choose carefully me thinks !
Not good

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
they did it in 7 weeks think they may have been pressed for time

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
The rough parts on the tubes are where paint has been applied straight over the wax oil and dirt.the piccys were after i cleaned up for an hour around main chassis etc.Not to worried about bare welds just not to happy with the tube alignment.on this side the tube steps one way about 5mm.On the other side the tubes line up but there is a real bend where they join.The tyre fitter who was putting new rubber on the front called me in to show me and said he thought it was disgusting,first time ive really had time to get under and have a good look.have decided to clean up the welds/treat and then fill the tubes to try and flush em out.As you can see tha main chassis is in really good nick,its a shame this has happened and more time will need to be spent to sort this out.my drivers side was in good nick but i thought i would have both sides done to save later visits....and to enhance the carrolleyes

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
.
not sure if you can see from photo the bend in this tube.

grngriff

187 posts

185 months

Monday 9th April 2012
quotequote all
Not what you'd expect at all,would of thought you would use some type of pipe clamp for alignment before welding!
Thinking of taking mine to tvr power, stourbridge. £1300 plus vat only about an hour and half drive fom me.
Feel for you,I'd be gutted myself.

Pete

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
bud this saga started last year when a local indie damaged the drivers side,and said they did'nt.So thought i would bite the bullet after finding rot on passengers side...after a 250 quid inspection told me they were finerolleyes,hence my reason to try a new garage.Was quoted on the phone and paid what i was quoted...this was slightly cheaper than online price.Not annoyed cos this seems the norm down here,dont want to knock good workmanship cos there are people out there with pride and time to do a good job....thing is i looked into this and the garage were recommended.

grngriff

187 posts

185 months

Monday 9th April 2012
quotequote all
Just because they quote less than others to win the work,quality and pride should always take precidence !
Had a look into mb motorsports down your way,seem reasonbly priced but after looking on the map, tooo far to go.
Who did yours or is there posting rules?

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
posting rules sir,dont want to get told off.think your choice of tvr power will be fine....wish i had gone to them now.my spongy thread is a good view wink

mickk

30,453 posts

271 months

Monday 9th April 2012
quotequote all
Have you spoke to the garage who have done the work, and do they carry any warranty?

Hard to tell from the pics, how has the weld been done?

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
The weld is ok in my book..its just the tubes dont line up.They are butt welds and are slightly high,but this is no problem as i can clean em up.you can see in the first piccy how the tubes dont line up.also on the drivers side the tube is bent...again not to a stupid degree but there is a definate bend...again i can loose some of this with careful filling.This was only spotted on saturday at about 5 so have not spoken to garage yet.

scotty_d

6,795 posts

223 months

Monday 9th April 2012
quotequote all
Can you PM me Spongy who did this, think i have a idea but just to confirm.

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
scotty_d said:
Can you PM me Spongy who did this, think i have a idea but just to confirm.
YHM

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
on the plus side the car is running better biggrin

Gazzab

21,637 posts

311 months

Monday 9th April 2012
quotequote all
Sorry to see that the repairs arent great. :-(
I presume they must have explained that they were doing a 'best efforts' and that the finish would be a little rough?

spongy

Original Poster:

2,236 posts

190 months

Monday 9th April 2012
quotequote all
Gazzab said:
Sorry to see that the repairs arent great. :-(
I presume they must have explained that they were doing a 'best efforts' and that the finish would be a little rough?
Lol no they said the welds would be really clean and i would hardly notice emeekand that is really what they said.the trouble was the car was booked in for 3 weeks max in the first instance,anyway nearly 8 weeks later i get her back,would have wanted to see car on ramps so i could inspect the work but the ramps were all being used,plus i trusted em bangheadso you could say this is kinda my fault too

scotty_d

6,795 posts

223 months

Monday 9th April 2012
quotequote all
Painting over waxoyl and dirt come on what kind of workmanship is that. Basic stuff mad

Gazzab

21,637 posts

311 months

Monday 9th April 2012
quotequote all
I would give them the opportunity to redo it or to refund you.