Oil Water and PAS pump photo

[R8nan]

Hi, Would anyone have a good photo of the Oil, water and PAS pump assembly that they could upload for me to look at? I would like to see how the two flanges are joined between the PAS pump and the flange at the end of the shaft from the oil and water pump.

Cheers

[mikesr]

Does this help?

[R8nan]

Hi, Thanks for the photo, the part I need to see is the join between the two flanges where I have pointed to in your photo.
Ps That is one cleen engine, what did you use to clean it?

[mikesr]

The finish is engine paint. There was a fair bit of corrosion so I decided to seal the surface to provide some protection.

This pic is the only one I can find which isn't much help.
The PAS pump has a triangular adapter on it with 3 pins that engage with the circular drive plate that slides onto the pump shaft and is grub screwed to secure it.

There should be 3 tube shaped rubber grommets in the holes in the circular plate that the drive pins on the PAS pump adapter fit into.

[R8nan]

Thanks for the info that answers all my questions. I couldnt remember if the two flat surfaces had small spacers between them.
Cheers

[ukkid35]

Don't assume that if the PS pump stops working it's terminal. There is a grub screw that secures part of the drive assembly, this can come loose and then the pump will no longer be turning. Probably the easiest cheapest fix possible.

[Mr Cerbera]

Good Grief That is pure Car Porn.

Mmmmmmmmmm !
;o)

Oh Yes, any pointer as to where I can acquire some of that marvellous "Engine Paint" ?

Ta !

Mr. Motah Da Vince

[skidoo]

it looks like the same paint i used its called "MOTOR COATER" you can get it off ebay (see thread at top of page two)