Cooling Pipes/Hoses Replaced - Does this Look Right?
Discussion
Hi,
I think I put everything back in correctly - but before I tighten it all up and refill could someone just glance over the attached and tell me if it looks right? My only real doubt, is potentially fundamental, do both main hoses going down from the engine go into the same S/S pipe (labelled 1)? and the hose that goes to the bottom of the engine connects into the radiator pipe (labelled 2).

Whilst doing this job I must admit to being pretty impressed by the original powder coating - the majority of it was still very much there after 12 years, it's pretty well protected in there but even so. Hope it's even half that good underneath....somehow I doubt it...
Cheers
Joe
Joe
I think I put everything back in correctly - but before I tighten it all up and refill could someone just glance over the attached and tell me if it looks right? My only real doubt, is potentially fundamental, do both main hoses going down from the engine go into the same S/S pipe (labelled 1)? and the hose that goes to the bottom of the engine connects into the radiator pipe (labelled 2).
Whilst doing this job I must admit to being pretty impressed by the original powder coating - the majority of it was still very much there after 12 years, it's pretty well protected in there but even so. Hope it's even half that good underneath....somehow I doubt it...
Cheers
Joe
Joe
Gassing Station | Cerbera | Top of Page | What's New | My Stuff


