Rear Wheel Bearing
Discussion
Failed the MOT due to play in the rear nearside wheel bearing. How easy is it to replace. I have already had the rear wheel, caliper and disk off to have a quick look. I would need to purchase a 42mm socket and looks like I can get the complete wheel bearing from TVR Power,any other tools required. Is it a job for the pros or can I do it keeping in mind I have never done anything like this before? Is there any setup required after,etc
Edited by TVR_CS on Sunday 23 June 18:39
It's fairly simple DIY but just bear in mind the torque required on the hub nut and depending on which side of the car it is, one of the hub nuts is a LH thread (can't remember off-hand).
As for the bearing itself, IIRC it is Jeep part but a quick scan of the alternative parts list should give you all the details you need.
M
As for the bearing itself, IIRC it is Jeep part but a quick scan of the alternative parts list should give you all the details you need.
M
Gassing Station | Cerbera | Top of Page | What's New | My Stuff