Fuse box

[dswiscrazy]

Does anyone know
Which circuit number 15 fuse
Is There's a 20 amp fuse in it
This could be the wrong size
But mine blows As soon as you turn on the ignition
Our is it a case of looking In Tvr Electrical manual
Page 1 Paragraph 1. Your f@@@k

[pmessling]

Engine fan 2 should be 30amp

[pmessling]

http://www.thetvrsite.com/files/wiring-diagrams/fu...

[sonnylad]

I would investigate why it blows first rather than just increasing amps.

If its fan then it should not be on from the start.

[SimonKD]

Would I be right in thinking early Cerbera fuse boxes do not look like this?



Fuse 15 may be for something else on a 1997 Cerbera.

Just a thought

Regards
Simon

[Supateg]

doesn't the ECU under certain fault conditions (sensor malfunction) engage the fans?
Carn't remember which ones, but at a guess water temp?
Worth hooking up the software and looking at the figures.

[dswiscrazy]

http://www.thetvrsite.com/files/wiring-diagrams/fu...
Thanks this Has narrowed it down
My indicators and brakelights Aren't working
Indicators reverse lights and brake light
Are all covered with the same fuse
At least I know where to start looking

[ukkid35]

Supateg said:

doesn't the ECU under certain fault conditions (sensor malfunction) engage the fans?
Carn't remember which ones, but at a guess water temp?
Worth hooking up the software and looking at the figures.

Yes - remove the water temp sensor connector on the water rail and both fans should run.

[dswiscrazy]

Problem located Since only thing I've done is take out the engine
And gearbox And the indicators reverse lights and brake light don't work
But the Hazards do and I've not Touch The brakes
Leaves the reverse sensor on the gearbox
The artist one to get And found That Wire.
Look like Someone's gone down with the Stanley knife
Managed to isolate it But that's going to be a nice job
At least I've gotten breaks and indicators