Rear upright bush question - help!
Discussion
Just swapping my rear hub / bearing
No real dramas, but whilst swinging the upright up from the lower wishbone to gain enough clearance between the drive shaft and the back of the hub access to 3 hex hub bolts, two washers fell on the floor.
Can only assume these are packing washers on the lower wishbone bushes that are hidden at the back of the carrier / upright. The outer sides of the 2 lower bushes has a plastic thrust washer.
Can anyone help. Don't want to put it all back together not knowing where they came from.
Cheers in advance
No real dramas, but whilst swinging the upright up from the lower wishbone to gain enough clearance between the drive shaft and the back of the hub access to 3 hex hub bolts, two washers fell on the floor.
Can only assume these are packing washers on the lower wishbone bushes that are hidden at the back of the carrier / upright. The outer sides of the 2 lower bushes has a plastic thrust washer.
Can anyone help. Don't want to put it all back together not knowing where they came from.
Cheers in advance
It it a plastic or steel washer?
On my Griff it works like this
Plastic are spacers for the ends of the wishbone bushes
Steel are under the nuts attached to the bolts holding the wishbone to the hub
There is an odd washer with a flat edge cut into it, this goes on the nut inside the bottom of the hub.
On my Griff it works like this
Plastic are spacers for the ends of the wishbone bushes
Steel are under the nuts attached to the bolts holding the wishbone to the hub
There is an odd washer with a flat edge cut into it, this goes on the nut inside the bottom of the hub.
Thanks
Two steel washers dropped out from the lower bushes. Each bush has one plastic washer like you say and it sits over one end of the bush between the bush and wishbone, I can only assume the 2 steel washers are from the other end of both bushes and again are sandwiched between the bush and wishbone to take up the slack if that makes sense?
The 2 lower bush bolts each have two outer steel washers so it's not them.
????
Two steel washers dropped out from the lower bushes. Each bush has one plastic washer like you say and it sits over one end of the bush between the bush and wishbone, I can only assume the 2 steel washers are from the other end of both bushes and again are sandwiched between the bush and wishbone to take up the slack if that makes sense?
The 2 lower bush bolts each have two outer steel washers so it's not them.
????
Gassing Station | Cerbera | Top of Page | What's New | My Stuff