Alarm not putting windows up
Discussion
My poor Cerb has been sat for a while.. Now the alarm/windows/doors have begun some strange behavior..
Alarm arms fine, de-activates the doors/boot etc. However, it has stopped putting the windows up.. Also, if you disconnect the battery, when you reconnect it, the doors/boot don't work until you press the interior lock switch.
Windows work fine/normal, drop when you open the door, close when you shut it (always leaves a gap apart from first time after turning alarm off). Doors work fine.
Where do we begin with this one? Check for a signal on B3 Connector J45? Alarm input to the control box?
Alarm is fairly new, battery is new, Control box was refurbished when a dead window motor blew it up. Earths are new. It was working fine, until very recently. It has been parked up for about 2.5yrs now.
Alarm arms fine, de-activates the doors/boot etc. However, it has stopped putting the windows up.. Also, if you disconnect the battery, when you reconnect it, the doors/boot don't work until you press the interior lock switch.
Windows work fine/normal, drop when you open the door, close when you shut it (always leaves a gap apart from first time after turning alarm off). Doors work fine.
Where do we begin with this one? Check for a signal on B3 Connector J45? Alarm input to the control box?
Alarm is fairly new, battery is new, Control box was refurbished when a dead window motor blew it up. Earths are new. It was working fine, until very recently. It has been parked up for about 2.5yrs now.
Jhonno said:
To possibly kind of answer my own question after printing the wiring diagram off..
The control box must be receiving a signal from the alarm as it locks the doors, so therefore it must be a fault within the box itself, stopping it putting a window up signal out to the windows.
Try unplugging the box for a bit then reconnect making sure all the plugs go in the correct socket, this has sorted mine on more than one occasion after it threw a hissy fit.The control box must be receiving a signal from the alarm as it locks the doors, so therefore it must be a fault within the box itself, stopping it putting a window up signal out to the windows.
gruffalo said:
Jhonno said:
To possibly kind of answer my own question after printing the wiring diagram off..
The control box must be receiving a signal from the alarm as it locks the doors, so therefore it must be a fault within the box itself, stopping it putting a window up signal out to the windows.
Try unplugging the box for a bit then reconnect making sure all the plugs go in the correct socket, this has sorted mine on more than one occasion after it threw a hissy fit.The control box must be receiving a signal from the alarm as it locks the doors, so therefore it must be a fault within the box itself, stopping it putting a window up signal out to the windows.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff