Ribbon cable

[QuiteQuietCerb]

Hi looking to change my 10 pin ribbon cable on the car as I think it’s damaged through bending . The tvr supplier cost is quite high for those. Has anyone found an alternative supplier or the spec. Looked at the below but not sure as it’s a 2mm pin

[Penelope Stopit]

You will have nothing but trouble using a cable of that type

Needs to be of FFC type (Flat Flexible Cable)

http://www.nicomatic.com/product-cbles_ffc-61-en.h...

This company might make one for you https://www.nicomatic.com/product-crimpflex_jumper...

Discussed here https://www.pistonheads.com/gassing/topic.asp?h=0&...

[Penelope Stopit]

FFC cable for steering wheel airbag, cable must be able to freely tighten and loosen (coil in, coil out)

[QuiteQuietCerb]

Thanks the cable is for the heater unit so no need to flex etc does anyone know the spec ? I ll check the other thread too. Thanks

[Byker28i]

When my steering wheel one broke I didn't fancy paying £80 for one, so opened the plug, cut off the broken part, sanded back the ribbon cable to expose the contacts and soldered it back on.