Diff Output Shaft Seals

[WIL35]

I seem to have a slight leak from an offside output seal on my diff.

I've replaced an input seal on my previous Cerb, but what is involved to change the output seal? Can it be reasonably easily done in situ once the driveshaft is disconnected and how is the flange connected to the diff?

Thanks

[TwinKam]

Flange just 'pops' out, retained by a snap ring (like an inner CV Joint into the trans on a fwd car). Big lever, sharp swing. Access may be a problem though!

Edited by TwinKam on Monday 11th April 09:51

Edited by TwinKam on Monday 11th April 09:52

[WIL35]

That's very helpful. I think I could give that a go, will order a new seal. Thanks!