need to bled radiator, wheres the brass screw?

[danfrith]

I think i have air in the system, i need to bled the radiator and then the bleed screws! I know where the bleed screws are! but is the brass screw for the radiator that bolt next to the power steering reservoir? if not can anyone tell me where the brass screw on the rad is to let some air out!

any help would be greatly appreciated.

cheers

Dan

[SXS]

Try them all, I'm sure you'll know you found the right one when it starts pouring out...

[budaholic]

Your right, the bleed screw is on the top corner of the rad next to the PAS fluid cap.
There are also 2 bleed valves on the water rails below your airboxes but personally, I've never had to touch them. I managed to re-fill my system just using the rad one.

Bud

[kojak]

budaholic said:

Your right, the bleed screw is on the top corner of the rad next to the PAS fluid cap. There are also 2 bleed valves on the water rails below your airboxes but personally, I've never had to touch them. I managed to re-fill my system just using the rad one. Bud

Agree with this. I didn't have to touch mine on the bleed rails. In fact, Joolz recommends not to touch them.

[danfrith]

thanks guys got it sussed in the end! seems fine now!

cheers

[extra 300 driver]

Usually takes about 6 cycles of hot/cold to get all the air out. If you have a jumping trmp guage then there is still air in the system somewhere.