Speedo
Author
Discussion

simonkd

Original Poster:

1,386 posts

260 months

Sunday 4th September 2005
quotequote all
Just a question, where does the speedo get it's pickup from? Mine has started playing up and not reading below 40 mph and Im guessing it's the sensor?

Cyclone1

2,614 posts

275 months

Sunday 4th September 2005
quotequote all
If it's not the speedo itself that is at fault, then the sensor from which it takes its reading is located at the drivers side of the Diff, sometimes it is mounted on the other side.

simonkd

Original Poster:

1,386 posts

260 months

Sunday 4th September 2005
quotequote all
So it probably has got something to do with the fact I've just had some work done on my diff

RUSSELLM

6,002 posts

276 months

Monday 5th September 2005
quotequote all
Simon, is it reading 40 when your standing still ? (ignition off ?)

mike_e

595 posts

292 months

Monday 5th September 2005
quotequote all
simonkd said:
So it probably has got something to do with the fact I've just had some work done on my diff


Sounds most likely, did this occur when you got the car back?

The sensor is mounted on the diff, look for the toothed wheel mounted inboard of the CV joint, the sensor is the cylindrical tube with two wires coming out the back. I suspect that the gap is too large, try reducing the distance between sensor and rotor teeth.

nervous

24,050 posts

259 months

Monday 5th September 2005
quotequote all
you might wanna take the time to make your hands and forearms triple jointed before you make the adjustment though. this will aid matters considerably.

simonkd

Original Poster:

1,386 posts

260 months

Monday 5th September 2005
quotequote all
No Russ, it reads all over the place at speeds less than 30 then fine from 35 upwards. I had a different diff fitted last week (tongue twister) while mine is refurbed and problem has arose since then. Cheers for info folks
Regards
Simon

simonkd

Original Poster:

1,386 posts

260 months

Monday 5th September 2005
quotequote all
It also reads 0 at standstill as expected.

Cyclone1

2,614 posts

275 months

Tuesday 6th September 2005
quotequote all
If you've just had the diff replaced then it will definitely be that the sensor has been refitted incorrectly, it will just need positioning closer.

simonkd

Original Poster:

1,386 posts

260 months

Tuesday 6th September 2005
quotequote all
Cheers Cyclone, I'll get it back to the garage to have it checked and or moved closer.
ps did the Emerald ecu make much differance to the cars performance or was it already on when you bought her?

Cyclone1

2,614 posts

275 months

Tuesday 6th September 2005
quotequote all
Hi Simon,

Yes it made a very noticeable difference, power increased from 340bhp to 390bhp with the Emerald alone, a few other light mods have taken it to near 400bhp, driveability is much improved also. It is also a more flexible option for future tuning than ia available with the existing MBE unit.

It's excellent value for money, drop Trackcar an email through his profile and he'll fill you in with more info, alternatively drop me an email through my profile.