Cerbera 4.5 timing table
Discussion
Gentlemen,
I am currently wiring my Cerbera up for a Haltech nexus R3. (Video to come)
In the evening once i am sick of crimping and stripping I am trying to get some sort of a plausible configuration on the haltech software. At this stage i figure I will run it based on TPSxRPM (same as stock) even though the Haltech has a built in MAP sensor (which maybe will come in useful once it's all running??)
Does anybody have the stock TPSxRPM timing table? Even if I pull a couple of degrees out for safety it would be helpful to get me in the ballpark.
Regards
Simon
I am currently wiring my Cerbera up for a Haltech nexus R3. (Video to come)
In the evening once i am sick of crimping and stripping I am trying to get some sort of a plausible configuration on the haltech software. At this stage i figure I will run it based on TPSxRPM (same as stock) even though the Haltech has a built in MAP sensor (which maybe will come in useful once it's all running??)
Does anybody have the stock TPSxRPM timing table? Even if I pull a couple of degrees out for safety it would be helpful to get me in the ballpark.
Regards
Simon
Gassing Station | Cerbera | Top of Page | What's New | My Stuff