Windows and window motor - experience?
Discussion
My cerb has caught the 'window not dropping' and 'interior light staying on' bug.
Done a search and its been covered well over the years.
While the door card is off I was thinking about replacing the leccy window motor.
The drivers side window motor is geriatric.
If I leave it half down and shut the door it doesnt make it all the way to the top.
Any mileage in stripping?
Looked on the parts list - not there - TVR only?
ta
Done a search and its been covered well over the years.
While the door card is off I was thinking about replacing the leccy window motor.
The drivers side window motor is geriatric.
If I leave it half down and shut the door it doesnt make it all the way to the top.
Any mileage in stripping?
Looked on the parts list - not there - TVR only?
ta
easto said:
My cerb has caught the 'window not dropping' and 'interior light staying on' bug.
Done a search and its been covered well over the years.
While the door card is off I was thinking about replacing the leccy window motor.
The drivers side window motor is geriatric.
If I leave it half down and shut the door it doesnt make it all the way to the top.
Any mileage in stripping?
Looked on the parts list - not there - TVR only?
ta
Do you know how to fix it???
I've had a couple of problems with mine. The passenger side motor needed a new wire for some reason. The drivers side stopped the other day, but it turned out to be the little plug that goes into the motor was dirty.
Grease the runners and clean up the connections first, then use a multimeter to check that +12 or -12 volts is getting through when you press the buttons.
Grease the runners and clean up the connections first, then use a multimeter to check that +12 or -12 volts is getting through when you press the buttons.

See my thread from last year.
www.pistonheads.com/gassing/topic.asp?t=90556
Hope this is the problem.
www.pistonheads.com/gassing/topic.asp?t=90556
Hope this is the problem.
Not sure if I can fix it or not to be honest...I am not the best with a spanner!
Hoping its just connections etc. that would be a result.
I assumed it would be a worn motor as it is very slow when the weight is against it, some days it almost stops when trying to put it up.
Of course i will check the easy/obvious things first.
Cheers for the replies!
Hoping its just connections etc. that would be a result.
I assumed it would be a worn motor as it is very slow when the weight is against it, some days it almost stops when trying to put it up.
Of course i will check the easy/obvious things first.
Cheers for the replies!
Gassing Station | Cerbera | Top of Page | What's New | My Stuff




(keeping it on topic)