Front Beam Single Point Jacking & Headlamp Upgrade

[robertjp]

Help Please!

Is there a single point on the front of the Cerby chassis where it's safe to jack?

I have highlighted the two i had thought...which one, top or bottom of the two?

Or should it not be attempted from a single point?

I am not keen on doing one side at a time...



I am going to attempt my headlight upgrade this week, but need to to have a good look at whats going on. Where is the current wiring hidden? I had assumed it was in the front valance - although not sure where they actually arrive from the control box in the back?

Thanks!

Rob

[budaholic]

If I need to jack up the front, I always use the top crossmember in your pic.
I usually place the jack right by the towing eye!

Don't mean to preach, but please remember, never rely on a jack alone, always support the car on 2 axle stands. Be safe!

Bud

[robertjp]

budaholic said:

If I need to jack up the front, I always use the top crossmember in your pic. I usually place the jack right by the towing eye! Don't mean to preach, but please remember, never rely on a jack alone, always support the car on 2 axle stands. Be safe! Bud

Will do...just wanted to be safe with the jack too (for the cerb that is!)

Thanks...

[satman]

robertjp said:

Where is the current wiring hidden? Rob

I think from memory that the wiring runs inside each wing from the bulkhead end, and that nothing actually passes across from one side to the other via the valance.