check and be safe
check and be safe
Author
Discussion

Jonnie B

Original Poster:

229 posts

248 months

Thursday 16th March 2006
quotequote all
I just been checking over my cerb,and ive just spoted somthing others should lookout for.

The front lower fibreglass cover that is a swine to get passed the water hose has chewed through one of my front aircon pipes (front of the engine) and started on the other rubber pipes there,i now know why the air con was't working.

Im going to change the hose myself as the system has completly degased itself and get regased at a garage.

Question do the nuts or thread at either end need any speacial sealer, or i they just tightened up like any normal nut.

Thanks john


luckyone

1,091 posts

261 months

Thursday 16th March 2006
quotequote all
Jonnie B said:
I just been checking over my cerb,and ive just spoted somthing others should lookout for.

The front lower fibreglass cover that is a swine to get passed the water hose has chewed through one of my front aircon pipes (front of the engine) and started on the other rubber pipes there,i now know why the air con was't working.

Im going to change the hose myself as the system has completly degased itself and get regased at a garage.

Question do the nuts or thread at either end need any speacial sealer, or i they just tightened up like any normal nut.

Thanks john




What a pain, ours has a second pipe cut though & slipped over all the pipes where they pass sharp edges, other people on here have mentioned theirs have them too.

I don’t know about the ends, but I’d think may find you need more than just the pipe, if any muck has got in to the system & you run it up it could do a lot of damage. Ours had a collapsed pipe (from a pervious bad repair) & it cost a small fortune to have it put right.

Cooky

4,955 posts

266 months

Thursday 16th March 2006
quotequote all
Just wrap some PTFE tape around the male adaptors once cleaned up if req. and screw the hose assembly on. Don't use any sealers.

jesfirth

1,743 posts

271 months

Friday 17th March 2006
quotequote all
I smeared mine in vaseloine and it seems to be ok. i delibrately chose this cos it works on the swimming pool pumps pipes etc to provide an airtight seal but doesnt set

Cyclone1

2,614 posts

275 months

Friday 17th March 2006
quotequote all
I noticed the same on mine, but luckily caught it early. I decided to wrap a piece of silicon hose around it with a tie wrap to hold it in place. If you look at the pic below you'll see the air-con hose in the bottom right hand corner of the pic, with the purple silicon hose in place.

Jonnie B

Original Poster:

229 posts

248 months

Friday 17th March 2006
quotequote all
Cheer's thanks for the advice, will get it sorted soon once the new pipe arives.

Toady1

1,622 posts

253 months

Friday 17th March 2006
quotequote all
nice spot. I dont have that problem as dont have air con!