Newbie with ECU issue
Newbie with ECU issue
Author
Discussion

peternib

Original Poster:

98 posts

260 months

Monday 27th March 2006
quotequote all
Hi All,
New to the world of Cerberas as i changed my griff500 for a 4.2 last month... All was going well until the MIL light began to flash on applying throttle! It turns out the ECU has had it..

Any suggestions as to where i get a new one without shelling out £800 odd quid??

From previous posts the most problems seemed to be resolved by resetting, apparently not in my case. i know the mechanic is Good at what he does so....

Please help

Peter.

cerealsurfer

594 posts

292 months

Monday 27th March 2006
quotequote all
Douglas Valley Breakers....

trackcar

6,453 posts

255 months

Monday 27th March 2006
quotequote all
That's a shame, and incerdibly rare. I've replaced two ecus in all the years cerberas have been out .. about 11 years. Is it on full throttle or when pressing the throttle down that it happens?

ridds

8,372 posts

273 months

Monday 27th March 2006
quotequote all
I would always be incredibly wary of anyone who says that an ECU is knackered.

gazzab

21,637 posts

311 months

Monday 27th March 2006
quotequote all
Is your guy a cerbie expert?

byff

4,427 posts

290 months

Monday 27th March 2006
quotequote all
I had a dodgy ECU on my last 4.5, but the dealer replaced the chip and it was ok after that. Cost about £60 from memory (my memory is crap, allow for +/- £20), so either Hexham is very generous or your getting ripped off.

peternib

Original Poster:

98 posts

260 months

Monday 27th March 2006
quotequote all
Yea the guy who is looking at it has verified that it is the ECU and now that ive dug deeper it turns out that the factory have refurbed this ECU before.....

Leave it to me to find the only F****d ecu in UK!

Im sending it back to B'pool they can sort it out! afterall they know it, as it spends weekends and all holidays there!

thanks for your posts, just want the car back now.

purpleheadedcerb

1,143 posts

251 months

Monday 27th March 2006
quotequote all
I'd be tempted to purchase a s/h good one and send them the bill. Or buy one and then sell it on when you get the original back.

Best of luck. Hope you get it sorted quickly.

tvr7s

73 posts

260 months

Monday 27th March 2006
quotequote all
Try the ECU doctor, 01752 346437, does fault finding and reconditioning with 12 month warranty, be wary of some companies on the net that claim to do reconditioning of ECU's, not wanting to mention any names but there are some cowboys out there and I found out the hard way! ECU doctor was the only one that offered a full 12 month warranty and seemed to know what he was talking about.

trackcar

6,453 posts

255 months

Monday 27th March 2006
quotequote all
I've had a couple where the NVRAM was the problem, simple chip change sorts that out .. but that only really affects the ecu's ability to store and use the adaptive trim function.
If you really do need an ecu it's well worth going the s/hand route .. as we say it's incredibly rare to have a failure so a s/hand ecu will probably be ok for another 20 years!
Just make sure you get one for AJP8 not a SP6 though! .. (early Cerbera SP6 used a gold casing ECU like the AJP8 versions, but the 15degree even bank timing offset is not a software change so you *do* need an AJP8 ecu to work on your car).

peternib

Original Poster:

98 posts

260 months

Tuesday 28th March 2006
quotequote all
Thanks for all your help guys, i will talk it over with the mechanic and sort it out with either a s/h ecu or send it to the doctor!

Thanks again

Peter