Discussion
Fixed my silent horn button yesterday, got new button and stickers form those nice chaps at Automedon.
The lead running from the bottom to the PCB connector inside the boss was missing a lot of its plastic insulation. Managed to get the 2 pin PCB connectors from Maplins (afraid I don't know the part no, should have made a note), All works a treat now.
Top tip if you replace any of these leads put some heat shrink over then as they tend to get worn where they rub on the ally back plates behind the steering wheel buttons.
The lead running from the bottom to the PCB connector inside the boss was missing a lot of its plastic insulation. Managed to get the 2 pin PCB connectors from Maplins (afraid I don't know the part no, should have made a note), All works a treat now.
Top tip if you replace any of these leads put some heat shrink over then as they tend to get worn where they rub on the ally back plates behind the steering wheel buttons.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff