Temperature max 70 degrees?
Temperature max 70 degrees?
Author
Discussion

dean_ratpac

Original Poster:

1,582 posts

307 months

Wednesday 21st June 2006
quotequote all
My cerb performed faultlessly throughout Le Mans. I used some water-wetter to keep it cool. Although on the way home in traffic I only reached a max of 70deg, now I’ve topped up with some more water, it doesn't seem to be on the gauge registering any higher than the previous 70 degrees. Could I have air in the system? Due to the summer coming up there's little antifreeze in there, it’s mainly water-wetter and water. Can anyone help?

The fans were on yesterday when I came back - but due to high speeds it never came off 5o degrees?

Please help... also noticed i've a blowing exhaust! Another one to fix!
Dean

Steve_T

6,356 posts

301 months

Wednesday 21st June 2006
quotequote all
Dean,

It sounds more like the capiliary for the temperature gauge has been dislodged/affected in some way. My temp gauge ended up like this when I had the water pipes replaced (I was warned that it might happen prior to doing the job). The ECU is supplied by an independent temperature sensor, so provided the fans are cutting in and out ok, you'll be alright until you get a new gauge fitted/do something else. When mine went I had an aftermarket fan controller fitted. I'm aiming to replace the original gauge with an oil temp/pressure gauge in the future.

Steve.

dean_ratpac

Original Poster:

1,582 posts

307 months

Wednesday 21st June 2006
quotequote all
thanks Steve, any idea where this capilary is, or where it feeds into?

Steve_T

6,356 posts

301 months

Wednesday 21st June 2006
quotequote all
You'll see it tie wrapped to the chassis rails - one end is terminated in a sender attached to the water pipes, the other attaches directly to the back of the gauge, within the instrument pod.

Steve

satman

2,455 posts

275 months

Wednesday 21st June 2006
quotequote all
Mine started to show lower and lower readings over a period of time, till eventually didnt read anything at all!...Had to replace the gauge!

longbow

1,610 posts

264 months

Wednesday 21st June 2006
quotequote all
Yeah, bit of a pig to replace though as the whole sensor needs to be fed through the engine bay grommet and through the pedal box - its all one piece.

budaholic

1,516 posts

264 months

Thursday 22nd June 2006
quotequote all
longbow said:
Yeah, bit of a pig to replace though as the whole sensor needs to be fed through the engine bay grommet and through the pedal box - its all one piece.


been there, done that!!

Bud