Discussion
mickk said:
Kerberos said:
Cheers, but what do I remove to get at it?
The moulded carpet type thingy drops down from under the dashsatman said:
mickk said:
Kerberos said:
Cheers, but what do I remove to get at it?
The moulded carpet type thingy drops down from under the dash
Yes, I think so.
Right I got inside the box and there's no 9 pin connector. There are two plugs on about 100mm of wire coming out of the harness in the top of the ecu. One's a two pin, the other a three pin. Is it one of these.
I've took a picture but can't suss out how to get it on here!
Right I got inside the box and there's no 9 pin connector. There are two plugs on about 100mm of wire coming out of the harness in the top of the ecu. One's a two pin, the other a three pin. Is it one of these.
I've took a picture but can't suss out how to get it on here!
Post your picture
http://ph.uncle-dave.co.uk/upload/
Then copy the URL it gives you, and paste it in between [pic]URL goes here[/pic]
http://ph.uncle-dave.co.uk/upload/
Then copy the URL it gives you, and paste it in between [pic]URL goes here[/pic]
I've just looking through numerous previous topics and I've found:
I've seen a link to a ready made cable but at £40 I'll try to make one first.
Any help appreciated
- It's the 3 pin cable
- It's the same plug as the back lights
- the cables connect 1-1, 2-2 & 3-3
I've seen a link to a ready made cable but at £40 I'll try to make one first.
Any help appreciated
Gassing Station | Cerbera | Top of Page | What's New | My Stuff



