Geometry Setup

[THE BIG DOG]

Anyone know of any where in the Cornwall area to get my geometry setup
check after the upper ball joint is replaced?
(TVR CERBERA)

[C2HYM]

Mines going to need doing soon, creaks every now and then. Peninsula TVR nr. Exeter said its not a big job, but the hardest bit is getting everything setup up again. Not sure if that means they can't do it, or if they can and its just a PITA if you know what I mean.

I'm North coast so Exeter is only an hour, but I could see if you're in deepest darkest then its going to be a bit of a drive.

[optimax sniffer]

Try dulfords as well.

[THE BIG DOG]

120 miles seems a long way just for a Geometry Setup!
Anyone closer?

[Olly]

Any decent tyre place/garage should be able to setup the suspension for you.


These are the settings for a 4.2 - not sure if they would be different for a 4.5 ?

Camber Degrees - 0.5 to 1.25 negative both front and rear

Caster Degrees - 3.5 to 4.5 positive front (rear n/a)

Toe Minutes - 10 to 20 in, both front and rear.
(the above is from the "Equivalent Part Numbers" thread)

[THE BIG DOG]

TOP MAN.
Very helpful info.
Thanks very much.