Front Splitter
Discussion
Muy front splitter is half hanging off on one side, and the threads on the screw hole have gone.
Rather than leave it in this half on/half off state and risk it all falling off at speed, i was wondering whether to take it off completely. Would this have a serious effect on car handling?
And if i left it as it is, would this have an effect also?
Thanks
Greg
Rather than leave it in this half on/half off state and risk it all falling off at speed, i was wondering whether to take it off completely. Would this have a serious effect on car handling?
And if i left it as it is, would this have an effect also?
Thanks
Greg
Don't have one on mine since a meeting with a ferry loading ramp thing last year - can't say I have noticed any increase in running temps and bonnet (on mine) has been fine at speeds upto about 160 in Germany - above those speeds I don't know and of course each car is a bit different so you could have lifting bonnet syndrome at lower speeds than mine. Better in the short term to run it without than risk it falling off and catching a tyre or flicking up at a car behind etc - then if it can be re-attached at next service then so much the better and if you find it no different anyway then maybe decide not to bother.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff





.