Clearingf CEL Light
Clearingf CEL Light
Author
Discussion

Tominski

Original Poster:

41 posts

227 months

Friday 4th January 2008
quotequote all

Since replacing my Alternator my CEL light has been beeping at me when I put ignition on but goes off when car starts.
I know its because I started the car with an injector plug put not seated correctly, but how do I reset the error codes on this car??

Thanks

julian64

14,325 posts

284 months

Friday 4th January 2008
quotequote all
Not sure what the CEL is but if you mean the engine MIL light and the buzzer. It should be constantly buzzing until the engine starts and should only turn off at that point.

Tominski

Original Poster:

41 posts

227 months

Friday 4th January 2008
quotequote all
Sorry... MIL not CEL...

Just dont remember it buzzing before...

julian64

14,325 posts

284 months

Friday 4th January 2008
quotequote all
In quite a lot of cerbs it doesn't.

However the ECU def seems to want it on til the car starts.

I remeber the last time I had mine out that there was a small inline fuse soldered to the back of the dash and a pot for loudness.

I had assumed on Cerbs this didn't happen on, the fuse had blown or the pot was turned right down.

jonbarrett

800 posts

232 months

Friday 4th January 2008
quotequote all
When I press the black button below the wheel certain low level systems start. Then I press the key fob and the fuel pump runs, MIL light comes on and a buzzer starts sounding. Then I press the black button, the car starts and the buzzer turns off.