Dashboard PCB or mil light wiring diagram wanted
Discussion
Hi !
Been reading electric diagrams for the Cerbera yesterday night. I have found this: the inertia switch has to functions, one is to cut the power to the fuelpump and the other is to send a signal to the mil light. There are two outputs from the inertia switch. The inertia switch error signal and the fault signal from the ECU are both connected to the dashboard PCB. In the ECU software manual it say that the inertia switch can trigger the mil light so in some way the two signals must be sent to the mil light. As far as I can see on the diagrams i have, this is made on the dashboard PCB-card.
Is there anyone that have a wiring diagram of the dashboard PCB, I have the diagram for the dashboard harness, but it isn´t detailed enough.
Peppe
Been reading electric diagrams for the Cerbera yesterday night. I have found this: the inertia switch has to functions, one is to cut the power to the fuelpump and the other is to send a signal to the mil light. There are two outputs from the inertia switch. The inertia switch error signal and the fault signal from the ECU are both connected to the dashboard PCB. In the ECU software manual it say that the inertia switch can trigger the mil light so in some way the two signals must be sent to the mil light. As far as I can see on the diagrams i have, this is made on the dashboard PCB-card.
Is there anyone that have a wiring diagram of the dashboard PCB, I have the diagram for the dashboard harness, but it isn´t detailed enough.
Peppe
Gassing Station | Cerbera | Top of Page | What's New | My Stuff