Can't put in gears - clutch problem

[ramuellert]

Hi folks,
i have a problem with my 98 4.5 cerbera. starting the engine, i can't put the gears in.
mls are now around 30000, clutch and slave cylinder were rebuild/replaced at 21000 mls, clutch fluid was changed yesterday but still the clutch does not separate and i am unable to put the gears in.
any ideas?

best regards

ramuellert

[esso]

Make sure that you have bled the clutch properly,then check the adjustment of the clutch pedal travel.This is done inside the car,there is an adjustable nut on a threaded rod behind the clutch pedal,try adjusting this to give you more travel on the clutch pedal.

[fatjon]

And after you think you have bled out all the air do it again a couple of times because you probably haven't. I had to put a fair bit of fluid through mine after letting the level drop too low and filling it with bubbles. For while I was convinced that the clutch was stuffed but after another dozen pumps and a couple more top ups it all worked fine and has done for a few thousand miles so far.