Prop to diff flange alignment

[high52kojak]

Had my diff refurbished and hoping to get it back on as soon as poss but one slight issue. I had to have a new diff input flange when it was refurbed as the courier dropped the diff, bending the flange quite a lot.
I marked the old one up with the prop before I took it off for alignment but obviously now I dont have any markings. Will it be ok to just bolt them up in any position? There are only four bolts so not many options anyway.

Thanks.

[Ireland]

high52kojak said:

..... Will it be ok to just bolt them up in any position? .....

Yes

[plumAJP]

I worried about as I could mount the prop 4 ways. in the end I mounted it, and while the car was running in gear with car in the air i just eyed it up to make sure it wasnt way out of balance and lightly put my hand around whil spinning it to make sure there was no big wobbles.

[ridds]

Pretty sure the prop will only go on one of 2 ways e.g 180° out due to hoe alignment.

The prop is a separate balanced entity on it's own so alignment with the diff flange is not important.

[BGB autosport]

Just make sure you give the prop flange a good clean ensuring no lumps on the mating face.