bonnet is lifting.
Discussion
Hi Guys
Just a quick quiry i have!!
the bonnet on my cerbera lifts when you going around 70mph or on a windy day when wind is blowing up the front end... seems to lift about an inch but when driving i cant tell if thats in the middle of the bonnet or the clip end...
The bonnet catch is turned closed all the way... how far do your nylon pins go into the catch????? I've put new bonnet rubber mushrooms on its made abit of diffrence but not alot.
Do cerbera bonnets usually move??? its very of putting!!!
Jack
Just a quick quiry i have!!
the bonnet on my cerbera lifts when you going around 70mph or on a windy day when wind is blowing up the front end... seems to lift about an inch but when driving i cant tell if thats in the middle of the bonnet or the clip end...
The bonnet catch is turned closed all the way... how far do your nylon pins go into the catch????? I've put new bonnet rubber mushrooms on its made abit of diffrence but not alot.
Do cerbera bonnets usually move??? its very of putting!!!
Jack
look underneath the front bumper and see if you have a small lip spoiler, more than likely it is missing (you will see a couple of small holes in the underside of the bumper where it was attached) this helps air flow at high speeds and stops your bonnet from lifting.
you could also play with the bonnet pins and wind them in a bit so they fit tighter and try putting a small piece of rubber on each side where the bonnet edges sit down by the lock pins, this will give a tighter fit and less movement.
you could also play with the bonnet pins and wind them in a bit so they fit tighter and try putting a small piece of rubber on each side where the bonnet edges sit down by the lock pins, this will give a tighter fit and less movement.
What condition are the rubber gromets in that fit into the plates on the underside of the bonnet its self?
If these wear or drop out the bonnet pins will just poke into a hole and leave room for movement. Standard cable grommets from Halfrauds assorted box fit fine and cure that problem readily.
If these wear or drop out the bonnet pins will just poke into a hole and leave room for movement. Standard cable grommets from Halfrauds assorted box fit fine and cure that problem readily.
CERB BOY said:
Hi all need a standard splitter as my car dose not have one .Dose anyone have dimensions as I would like to make sum in stainless steel.
Jon
Exactly what he said ^Jon
Any idea of where we can get one guys. When i drove mine home from buying it the other weekend the bonnet was trying to lift at 75.
If its the same as the Chim one i have loads at home i made up out of sheet ali, reason being that if i hit a high speedbump / small animal it will bend out of the way rather than rip the self tappers out of the fibreglass.
I'm already onto my second splitter after hitting a dead fox, but it did its job and just bent out of the way
If you want any dimensions i can measure it up tonight
I'm already onto my second splitter after hitting a dead fox, but it did its job and just bent out of the way
If you want any dimensions i can measure it up tonight
Gassing Station | Cerbera | Top of Page | What's New | My Stuff