Cerbera Windows

[Cerbie450]

Can anyone tell me if they have had problems when opening windows at high speeds they dont close properly. When the windows goes up, it seems to go about an inch away from where it should be at the top. Outside the rubber seal. Also would like to know if you have problems with wind noise and can this be rectified.

Help!!!!!!!!!

[GCerbera]

Can't help with the gap, others will no doubt, but
wind noise generally is the seal breaking down which
is quite common and not too hard to replace (or so I
am told!)

[pdavison]

Wind noise may well be coming from the hockey sticks, as the seals come loose the wind noise from these gets quite bad.

>> Edited by pdavison on Tuesday 24th February 16:23

[kojak69]

You can get a bit of wind noise.

There is a small magnet at the base of the doorframe. If that has fallen out the contact isnt made, the door thinks it is open still, and the window wont shut properly.

>> Edited by kojak69 on Tuesday 24th February 16:37

[dkurtaz]

Just fixed this on mine at the weekend-

1) take off inner door panel
2) You'll see two clamps holding the glass in place
3) Slacken these off, pull the window up in the clamp by the appropriate amount (10mm in my case)
4) re-tighten clamps
5) Put on door inner
6) Bob's your uncle
7) (And don't open windows at speed!)

>> Edited by dkurtaz on Tuesday 24th February 20:38

[ridds]

Yep, the windows can more a fair amount in the clamps and not jst up and down either. You need to ensure that they are sealed evenly all the way around.

Take the trim panels off and adjust to suit.