Passenger door problem.
Discussion
Passenger door window doesn't drop when opening the door. I've had a look at the contact at the bottom of the door, but not sure how its supposed to be set. Is it supposed to touch the sill, or not. (WHERES THE MAGNET? I cant see anything on either sills, so I assume theres something behind it, to make a contact!!).
I've also unpluged the control unit in the boot, but that's not cured it.
Also, the interia lights are stopping on.
Any ideas.
PS Drivers door/window is OK..even though cant see the magnet!!
>>> Edited by kojak69 on Wednesday 31st March 22:28
>>> Edited by kojak69 on Thursday 1st April 09:05
I've also unpluged the control unit in the boot, but that's not cured it.
Also, the interia lights are stopping on.
Any ideas.
PS Drivers door/window is OK..even though cant see the magnet!!
>>> Edited by kojak69 on Wednesday 31st March 22:28
>>> Edited by kojak69 on Thursday 1st April 09:05
This any help?
www.pistonheads.com/gassing/topic.asp?t=86226&f=6&h=0&hw=magnet
Apologies if you've already seen it.
www.pistonheads.com/gassing/topic.asp?t=86226&f=6&h=0&hw=magnet
Apologies if you've already seen it.
It turned out to be the 2 pin connector inside the door, that had corroded. Took the door panel off, and cleaned it. Bingo. Thanks Joolz.
Fot others wondering what i'm talking about, and for future reference, see below.
Connector (uncoupled) and switch shown at the bottom of the door.
>> Edited by kojak69 on Thursday 1st April 15:51
Fot others wondering what i'm talking about, and for future reference, see below.
Connector (uncoupled) and switch shown at the bottom of the door.
>> Edited by kojak69 on Thursday 1st April 15:51
Gassing Station | Cerbera | Top of Page | What's New | My Stuff


