Rear outboard driveshaft end?

[brakedust]

Another problem has cropped up during the back end rebuild...

While removing the rear hub nut from the passengers side hub the threads gave up and have let go, so im going to have to cut the nut off and fit a new shaft, the bloke in my HYD bay didn't realize it was a LH thread!

Its the bit that the drive shaft bolts to with the spline drive that engages in the bearing.. Anyone know if its off another car? Or where to get one?

Edited by brakedust on Wednesday 16th February 19:02

[brakedust]

Ok... after searching through the parts catalogue I found the part # and found this

http://www.tvrpower.co.uk/store/slug/rear-ouput-fl...

And I currently can genuinely not afford to spend that much on ANOTHER part (this re-con is beginning to cost a fortune!)

Any ideas what its off or is this a TVR own part?

[jammy_basturd]

Have you tried searching through the alternative parts list thread?

You could try the TVR breakers (Douglas Valley, Bell Hill), but on such a component I'd only place confidence in a new part.

[brakedust]

jammy_basturd said:

Have you tried searching through the alternative parts list thread?

You could try the TVR breakers (Douglas Valley, Bell Hill), but on such a component I'd only place confidence in a new part.

Yes I have looked in the alternate parts list, the hub/hearing assembly is off a Jeep, but there is no reference as to what the actual shaft that goes through it is.
Someone on the TVR general gassing has said they may have one so fingers crossed!
Just purchased a house and I'm a lower rank in the RAF so money is something im currently not swimming in! A trip to Afghan in Sep will help me save up and spend some money on her (rolling road tune with Joo is on the cards to bring my short induction and linked de-cats together!)