signs of clutch wear?? manual f430
signs of clutch wear?? manual f430
Author
Discussion

tuscaneer

Original Poster:

7,989 posts

256 months

Monday 2nd April 2012
quotequote all
i got a bit worried when my car was in for service and the guy mentioned that he felt the clutch bite was a bit low.with it being a manual there is no way to tell like in a paddle job.the clutch makes a bit of a squeaking noise every now and again.is this anything to be worried about,??cheers in advance

RVIANT

1,297 posts

284 months

Monday 2nd April 2012
quotequote all
they can check clutch wear on the SD2 plus adjust the biting point

JMP86

215 posts

177 months

Monday 2nd April 2012
quotequote all
Not with a manual car,

Only way to be sure is to take the clutch out & have a look, however you get a feel for where the biting point is on the pedal travel on a manual, which can give a rough idea

tuscaneer

Original Poster:

7,989 posts

256 months

Monday 2nd April 2012
quotequote all
cheers chaps, biting point is quite low which i suppose doesn't bode well...it's the sqeaky noise i'm a bit nonplussed about

roygarth

2,674 posts

279 months

Monday 2nd April 2012
quotequote all
tuscaneer said:
biting point is quite low which i suppose doesn't bode well
Are you sure that low is bad? Only ask as on my 993RS (only car where I've replaced a clutch) bite point went higher as it wore out....



tuscaneer

Original Poster:

7,989 posts

256 months

Monday 2nd April 2012
quotequote all
roygarth said:
Are you sure that low is bad? Only ask as on my 993RS (only car where I've replaced a clutch) bite point went higher as it wore out....
mmmm...i'm only going off what the service guy told me.and this is the first donkey for me so i don't have a lot of experience here .it's the squeak that had me worrying more so.i suppose clutch life is entirely dependant on driving style and as such i have a very careful and considerate way of driving

CIE560

19,655 posts

224 months

Monday 2nd April 2012
quotequote all
tuscaneer said:
i have a very careful and considerate way of driving
....and then you press the engine start button!

tuscaneer

Original Poster:

7,989 posts

256 months

Monday 2nd April 2012
quotequote all
ha! you've seen me about then!!??

CIE560

19,655 posts

224 months

Monday 2nd April 2012
quotequote all
Unfortunately not but I can't imagine you drive it like an old woman though biggrin

tuscaneer

Original Poster:

7,989 posts

256 months

Tuesday 3rd April 2012
quotequote all
ha ha!,, but seriously, i don't ever really spank my cars.never rev from cold, never ride the clutch etc. etc.
this car especially as i have a weird feeling it may be staying with me for a long time!

rawkyjnr

259 posts

202 months

Tuesday 17th April 2012
quotequote all
Dave I'm sure a low bite is good if anything!

If the plates wear, they're further apart when you've got your foot on the clutch, so wear would show itself as a high bite because you have to bring the plates closer together before they bite.

You sure the squeak isn't just the pedal pivot under the dash?


tuscaneer

Original Poster:

7,989 posts

256 months

Wednesday 18th April 2012
quotequote all
rawkyjnr said:
Dave I'm sure a low bite is good if anything!

If the plates wear, they're further apart when you've got your foot on the clutch, so wear would show itself as a high bite because you have to bring the plates closer together before they bite.

You sure the squeak isn't just the pedal pivot under the dash?
sounds logical but i remember the clutch going in my mk1 golf 18 years ago(bit before your time!!ha) the bite point got gradually lower until it wouldn't engage any more.i replaced it and it felt like my knee was up to my chest before the clutch engaged so now i'm more confused.

squeak definately from somewhere behind me; assuming it's a bearing or something.not really a bother but i don't want it turning into something toe curling

456GD

568 posts

223 months

Saturday 21st April 2012
quotequote all
Not sure it is the case with the 430 cars but in my 456 when I replaced the clutch (at 30k miles) the new clutch was much lighter to press. So it was getting harder with wear

MJK 24

5,679 posts

267 months

Saturday 21st April 2012
quotequote all
tuscaneer said:
sounds logical but i remember the clutch going in my mk1 golf 18 years ago(bit before your time!!ha) the bite point got gradually lower until it wouldn't engage any more.i replaced it and it felt like my knee was up to my chest before the clutch engaged so now i'm more confused.

squeak definately from somewhere behind me; assuming it's a bearing or something.not really a bother but i don't want it turning into something toe curling
Mk1 Golf had a cable operated clutch and wear in the cable would see the bite point go lower. Fitting a new cable and not adjusting it properly could see the bite point being very high.

The 355 has a hydraulically operated clutch which bypasses the hassles noted above.