F430 ride height
Author
Discussion

P101

Original Poster:

1,256 posts

189 months

Thursday 31st May 2012
quotequote all
The ride height of my 430 spider is slightly too low. I have been told by a local main dealer that raising the ride height is a big job, involves removing the suspension. Is that right? I had the ride height on my old Maserati 4200 adjusted several years ago, and it was fairly straight forward. Anyone know what's involved?

Cheers

Don1

16,881 posts

239 months

Thursday 31st May 2012
quotequote all
My guess would be down the the electronics and the dampers it would be more difficult that the Skyhook system the Maser has? At a guess?

UH-Matt

2,173 posts

271 months

Thursday 31st May 2012
quotequote all
The suspension can be adjusted on the car, but its easier to remove it. It is NOT a big job. When mine was adjusted lower (very low) the suspension was removed and I believe in total it was only about 3 hours work.

UH-Matt

2,173 posts

271 months

Thursday 31st May 2012
quotequote all
Also make sure you get a proper geo setup done once the suspension has been adjusted, transforms the car having proper geo turns it from a safe understeering mess of a setup into a proper drivers car wink

P101

Original Poster:

1,256 posts

189 months

Thursday 31st May 2012
quotequote all
My car is so low that in race mode the front scrapes on the road sometimes when cornering fast. Not entirely sure if I am going to adjust it yet as the lower ride height makes the car look so much better than the standard setup. I can remember when I got the masser done it was just a matter of winding a cog around the suspension arms, didn't take long. Prob about 20 mins per side.

P101

Original Poster:

1,256 posts

189 months

Thursday 31st May 2012
quotequote all
UH-Matt said:
Also make sure you get a proper geo setup done once the suspension has been adjusted, transforms the car having proper geo turns it from a safe understeering mess of a setup into a proper drivers car wink
I prefer safe to be honest!

Radders

288 posts

258 months

Thursday 31st May 2012
quotequote all
all F430's as standard from factory are on stilts! so yours must have been lowered at some point?

dropped my last spider on the floor, didn't give a fook about the scraping smile

Dropping the scud next week as thats also too high.

UH-Matt

2,173 posts

271 months

Thursday 31st May 2012
quotequote all
P101 said:
My car is so low that in race mode the front scrapes on the road sometimes when cornering fast. Not entirely sure if I am going to adjust it yet as the lower ride height makes the car look so much better than the standard setup. I can remember when I got the masser done it was just a matter of winding a cog around the suspension arms, didn't take long. Prob about 20 mins per side.

UH-Matt

2,173 posts

271 months

Thursday 31st May 2012
quotequote all
UH-Matt said:
Leave it. The odd scrape won't do any harm, can always add scuff plates under the bumper if you are worried.

bertie

8,569 posts

315 months

Thursday 31st May 2012
quotequote all
All this talk of reducing ride heights, it effects so many elements of the geo, toe, camber, bump steer, and not getting the right front to back rake makes a massive difference.
It can really screw up the handling.

Which are you interested in, handling or looks?

P101

Original Poster:

1,256 posts

189 months

Thursday 31st May 2012
quotequote all
bertie said:
All this talk of reducing ride heights, it effects so many elements of the geo, toe, camber, bump steer, and not getting the right front to back rake makes a massive difference.
It can really screw up the handling.

Which are you interested in, handling or looks?
A little bit of both. I feel as standard the 430 is too high. I don't like the big gaps in the wheel arch's.



bertie

8,569 posts

315 months

Thursday 31st May 2012
quotequote all
P101 said:
A little bit of both. I feel as standard the 430 is too high. I don't like the big gaps in the wheel arch's.


I presume that is after lowering?

As has been said before, if you want it to handle get a full geometry setup done at somewhere like http://www.centergravity.co.uk/

With the ammount of go an F430 has I think it's dangerous not to.

UH-Matt

2,173 posts

271 months

Friday 1st June 2012
quotequote all
bertie said:
All this talk of reducing ride heights, it effects so many elements of the geo, toe, camber, bump steer, and not getting the right front to back rake makes a massive difference.
It can really screw up the handling.

Which are you interested in, handling or looks?
I think most people would already know this, hence me suggesting that once the ride height has been adjusted to get a decent geo setup done. These cars IMPROVE hugely with a slight lower and a proper geo setup, there is no downside.

bertie

8,569 posts

315 months

Friday 1st June 2012
quotequote all
UH-Matt said:
I think most people would already know this, hence me suggesting that once the ride height has been adjusted to get a decent geo setup done. These cars IMPROVE hugely with a slight lower and a proper geo setup, there is no downside.
As you say a slight reduction with a proper geo might improve it, but it'll be the proper geo that's making the improvement, not the ride height.

I just worry about people slamming them to the ground and buggering the geo, seen it done before.

ShakMan

180 posts

313 months

Sunday 3rd June 2012
quotequote all
To avoid the scrapping you need to put stiffer springs in. If you drive it hard alot, you'll make a complete mess of that bumper.

Various options .... Novatech do a progressive spring setup which I have heard is very good (and not ridiculously expensive) and keeps the characteristics of the car pretty much similar. Other alternatives I have heard is to use Scud springs but the Titanium versions are $$$.

bromers2

1,867 posts

281 months

Sunday 3rd June 2012
quotequote all
No need for springs, 430 (and 360) has adjustable suspension - quick to adjust but then really need geo setup which can take the time.
Buy skid plates and keep low - handle better with a lower centre of gravity (although the 458 rides really high and that handles super).

markst

247 posts

196 months

Monday 4th June 2012
quotequote all
whilst it might look better.....dont do it, as it makes the car almost undrivable unless you are very careful.

be prepared to scrap you bumper over the smallest incline !


jackal

11,251 posts

313 months

Sunday 10th June 2012
quotequote all
This is an easy job. Get it down to qv london, they have done loads of them. A quick geo is of course required afterward. Scud height is the sensible option, -20 and -15 IIRC. Fit the cheaper non titanium scud springs if you want a stiffer ride as well. The springs rates in the stock 430 are fairly plush to say the least.

AndrewD

7,659 posts

315 months

Sunday 10th June 2012
quotequote all
jackal said:
This is an easy job. Get it down to qv london, they have done loads of them. A quick geo is of course required afterward. Scud height is the sensible option, -20 and -15 IIRC. Fit the cheaper non titanium scud springs if you want a stiffer ride as well. The springs rates in the stock 430 are fairly plush to say the least.
Have you bought one yet? smile

P101

Original Poster:

1,256 posts

189 months

Sunday 10th June 2012
quotequote all
I bought the car already lowered by someone else. I have noticed that it scrapes more when I have a passenger. I guess it must be the extra weight. The cars going back to Autofficina who I purchased it from to have some other niggles sorted out, I think I may get them to raise the suspension a little. Also get some scuff guards fitted.