Maserati 222se ihi turbos
Maserati 222se ihi turbos
Author
Discussion

matt-man

Original Poster:

2,667 posts

250 months

Monday 24th September 2012
quotequote all
Hi all, I know there isn't much of a following on here for the biturbos but I am reaching for help as I'm a but stuck!

My 222se 2.8 twin turbo has oil leaking through the turbos and was th cause of lots of smoke when lifting off and pulling away from idle.

Anyhow, the engine is out (good chance to do lot of jobs like the weeping rest main seal, new clutch, belts, cracked manifold weap ETC and the turbos have been sent off for refurb...

Now for the bad news, the turbos are cracked! The refurb company have said they can't fix them and I can't find replacements...anyone know anyone who might help???

yellowtr

1,190 posts

257 months

Monday 24th September 2012
quotequote all
I have a feeling that it shared the same Turbo's as a Lancia Y10 Turbo and if so I might be able to help as I had loads of this pocket rockets in the past and have a ton of spares for them. It might take a while to locate them, but I am sure I can find something. Drop us a PM.

crostonian

2,427 posts

203 months

Tuesday 25th September 2012
quotequote all
Assume you have tried David Askew, Eurospares, Bill McGraths and Autoshield?

Cerbieherts

1,652 posts

172 months

Tuesday 25th September 2012
quotequote all
Yes, try bill mcgraths, also give Tim a call at Emblem sports cars, they often have a few biturbo's laying about, and he will point you in the right direction. A word of advice if I may, if you plan on doing the valve clearances, the upper gaskets are no longer available so take care when you remove the cam block, save as much as you can of the old gasket as you will have to make new ones from gasket paper. Bill stocks all the shims apart from a few odd sizes. When you put the engine back, leave the PAS pump off until you have fitted the RH pipe to the turbo otherwise it's a real pain in the a**e!

Pork

9,455 posts

265 months

Tuesday 25th September 2012
quotequote all
My money is on Bill McGraths - if anyone is likely to be able to help, its them.

I went to their open day a while back and they buy cars just to strip them for part. They also regularly travel europe just for parts so I think there's a good chance they could help you.

www.classicmaseratis.co.uk

matt-man

Original Poster:

2,667 posts

250 months

Tuesday 25th September 2012
quotequote all
Hi all, thanks for your posts!!

I've got a few bits from eurospares and now only really using bill McGrath as they guys there are really very friendly and knowledgeable. Sadly they are still trying to help but no answer yet...I'm a but concerned as it's all in bits and I just waiting for the turbos!

I'm not planning on doing the valve clearances as it seems like quite a big job! I've not done many miles in the car since I've had it but apart from the turbos it ran really well!

I'll speak to the other company and see what I Can find....thanks for your help!!!

Cerbieherts

1,652 posts

172 months

Tuesday 25th September 2012
quotequote all
If you get stuck PM me, I've done a fair bit on the bi-turbo era cars and would be happy to help!

matt-man

Original Poster:

2,667 posts

250 months

Tuesday 9th October 2012
quotequote all
Well, I picked the car up this evening and it seems all good! Ended up getting replacement turbos from David askew and from the 30 miles I did getting it home it seemed fine! Ended up doing the belts, rear main seal, clutch etc etc so well worthwhile...

Can't wait to do some miles!