1994 ferrari 355 gtb ----suspension geometry settings
Discussion
Ride height:
front 162-171
rear 182-191
Camber f -50'/+-/10'
camber r -2 degrees/+-/10'
Toe f 2.5/+-/0.5mm
Toe R 7.5/+-/0.5mm
Caster (PAS) 7degrees/+-/10'
Caster (non PAS) 5degrees/+-/15'
Make sure the ride height is spot on, it makes a big difference to camber, and the springs sag with age.
If you have to adjust rear camber, be aware that the bottom brackets sometimes stick in the subframe, but usually shift with a tap using a rubber hammer...
front 162-171
rear 182-191
Camber f -50'/+-/10'
camber r -2 degrees/+-/10'
Toe f 2.5/+-/0.5mm
Toe R 7.5/+-/0.5mm
Caster (PAS) 7degrees/+-/10'
Caster (non PAS) 5degrees/+-/15'
Make sure the ride height is spot on, it makes a big difference to camber, and the springs sag with age.
If you have to adjust rear camber, be aware that the bottom brackets sometimes stick in the subframe, but usually shift with a tap using a rubber hammer...
OP - Are you aware that the car needs to be correctly weighted before the suspension is measured or adjusted, otherwise you are wasting your time.
When i had mine i had Maranello set it up for me and it really felt better afterwards, not that it felt bad before but none the less it did make a noticeable difference.
When i had mine i had Maranello set it up for me and it really felt better afterwards, not that it felt bad before but none the less it did make a noticeable difference.
Gassing Station | Supercar General | Top of Page | What's New | My Stuff


