Sealing ecu's ?
Author
Discussion

phib

Original Poster:

4,520 posts

290 months

Saturday 15th February 2014
quotequote all
HI have a 355 spider, runs perfectly always has.

However one of my ecu's needs re sealing, has anyone done this ? ( getting a bit of moisture in, all dried out now)

If so what did you re seal it with ?

Thanks

Phib

Cerbieherts

1,652 posts

172 months

Saturday 15th February 2014
quotequote all
Are you talking about the cat ecu's? You can use a decent silicon and run a thin bead between the case and the centre block. Be aware that if it's been wet/damp inside the unit will have started to corrode anyway and won't last as long as it should.

ZeusF

377 posts

154 months

Saturday 15th February 2014
quotequote all
Most auto parts stores hold black silicon sealer, this is what you need.
The ecu will have clips around the outer that you need to fold over firstly.
Having said that, the edu is in the car so why is it getting wet ?

Cerbieherts

1,652 posts

172 months

Saturday 15th February 2014
quotequote all
Not if it's an earlier 355 which uses 2.7 motronic, they are fitted with two ecu's in the engine bay.

ZeusF

377 posts

154 months

Saturday 15th February 2014
quotequote all
Cerbieherts said:
Not if it's an earlier 355 which uses 2.7 motronic, they are fitted with two ecu's in the engine bay.
Yes but clipped and not sealed as stock.

Cerbieherts

1,652 posts

172 months

Saturday 15th February 2014
quotequote all
They are sealed. They are in the engine bay, and not in the car unless 5.2. They don't normally suffer water ingress which is why I asked if it was the slow down ecu's that he wished to seal, as they are a common issue. There are two types, potted in either black or green resin. Early black units are more problematic but the greens also split and suffer. Over tightening the two seven mm screws that secure the units usually causes the splits to begin...

phib

Original Poster:

4,520 posts

290 months

Saturday 15th February 2014
quotequote all
Thanks for so many replies guys !!

Its a 5.2 car and its the one thats by the rear right hand wheel that has got moist !!! because basically the driver side rear wheel kicks spray into the cat ecu, especially with the very poor weather recently !!!

I never drive the car in the rain / wet but had to last weekend hence the moisture.

As soon as it got damp it was out and on the aga for 24hrs, all dried out and it runs perfectly again, no slow down lights no nothing.

I have one black one and one green one and its the green that was giving the issue.

Both are ok but have shrinked away ( only by 1mm in one / two places ) from the case

Hope that makes sense

Going to increase the length of the bolts when i replace and add a damper

Thanks

Phib

Cerbieherts

1,652 posts

172 months

Saturday 15th February 2014
quotequote all
Yes that's the one that usually suffers because, as you say, it's right in the line of fire for all the water and crud thrown up from the right rear wheel. Just remove it and seal up the cracks. Put it back with a decent sized washer on the bolts to spread the load a bit and stop the cracks opening up again..

phib

Original Poster:

4,520 posts

290 months

Saturday 15th February 2014
quotequote all
Great thanks for advice re washer

What a stupid place to put an ECU !!!!!!

Phib