Jump Start A 3200GT
Jump Start A 3200GT
Author
Discussion

S70JPS

Original Poster:

621 posts

241 months

Thursday 22nd December 2005
quotequote all
I am new to the site and have been reading through old posts. In one of them somone talked about jump starting a 3200GT. This is a complete no no. Doing so could damage the ECU. The best way to sort a flat battery is to trickle charge it (disconnected) overnight.

wicked1

146 posts

242 months

Saturday 24th December 2005
quotequote all
On any 3200Gt and all 4200Gt you can trickle charge the battery when you switch off the car by the actual isolator switch fitted on the o/s/r boot panel attached to the wheel arch, it is a big round knob and can be stiff to use at first. I think they were fitted from 2000 onwards. It basically stops the battery going flat in the first place and shuts the car down.

v12v8

1,153 posts

272 months

Sunday 25th December 2005
quotequote all
S70JPS said:
I am new to the site and have been reading through old posts. In one of them somone talked about jump starting a 3200GT. This is a complete no no. Doing so could damage the ECU. The best way to sort a flat battery is to trickle charge it (disconnected) overnight.


You can jump start them. I'm positive it tells you how to do so in the owner's manual.

3200gt

2,727 posts

245 months

Sunday 25th December 2005
quotequote all
Sure does.

1 connect live to live.
2 connect negative to negative.
3 start engine.
4 disconnect negative.
5 disconnect live.

So, just the same as any other car then!

page 76 in the owners manual under "emergency starting with auxilart battery"

>> Edited by 3200gt on Sunday 25th December 20:17

David A

3,707 posts

272 months

Sunday 25th December 2005
quotequote all
I think what they're getting at is not to attach another car / jump start device that could surge through the electronics, whereas anther battery wouldn't

nigelo

293 posts

254 months

Tuesday 27th December 2005
quotequote all
Don't disagree with the last 3 posts and just to add my two cents - If you are using a CTEK battery conditioner/charger or its equivalent, you do NOT need to disconnect or isolate the battery. The CTEK is made to be used for extended periods WITH the battery left connected.

hth