Monaro vxr driver side door air vent
Discussion
Hi,
I've got a problem with damp carpets on the drivers side of my 2004 monaro vxr which I'm looking into (seen the various articles on this already). Thought it might have been down to just the really strong winds and rain we've had over the last few weeks but not so sure now.
Removed the small triangular panel on the drivers side behind the mirror - the air vent/guide piece. Came off fine. Went to refit it, lined it up and tried pushing clip in - didn't push too hard and the clip broke into pieces and the section on the panel which it clips into appears to have broken too - brittle plastic?
Had a search on the internet and nothing obvious comes up for a replacement. Nothing on monkfish site when I checked earlier either. Anybody know where I can get a replacement from (panel and clips) or if there are other cars they can be sourced from - maybe a Vauxhall omega or something? Part numbers or "proper" manufacturer description would probably help too...
Thanks.
I've got a problem with damp carpets on the drivers side of my 2004 monaro vxr which I'm looking into (seen the various articles on this already). Thought it might have been down to just the really strong winds and rain we've had over the last few weeks but not so sure now.
Removed the small triangular panel on the drivers side behind the mirror - the air vent/guide piece. Came off fine. Went to refit it, lined it up and tried pushing clip in - didn't push too hard and the clip broke into pieces and the section on the panel which it clips into appears to have broken too - brittle plastic?
Had a search on the internet and nothing obvious comes up for a replacement. Nothing on monkfish site when I checked earlier either. Anybody know where I can get a replacement from (panel and clips) or if there are other cars they can be sourced from - maybe a Vauxhall omega or something? Part numbers or "proper" manufacturer description would probably help too...
Thanks.
FizzysCar said:
Hi,
I've got a problem with damp carpets on the drivers side of my 2004 monaro vxr which I'm looking into (seen the various articles on this already). Thought it might have been down to just the really strong winds and rain we've had over the last few weeks but not so sure now.
Removed the small triangular panel on the drivers side behind the mirror - the air vent/guide piece. Came off fine. Went to refit it, lined it up and tried pushing clip in - didn't push too hard and the clip broke into pieces and the section on the panel which it clips into appears to have broken too - brittle plastic?
Had a search on the internet and nothing obvious comes up for a replacement. Nothing on monkfish site when I checked earlier either. Anybody know where I can get a replacement from (panel and clips) or if there are other cars they can be sourced from - maybe a Vauxhall omega or something? Part numbers or "proper" manufacturer description would probably help too...
Thanks.
Have you tried the Talcum Powder Method to track down the Leak?I've got a problem with damp carpets on the drivers side of my 2004 monaro vxr which I'm looking into (seen the various articles on this already). Thought it might have been down to just the really strong winds and rain we've had over the last few weeks but not so sure now.
Removed the small triangular panel on the drivers side behind the mirror - the air vent/guide piece. Came off fine. Went to refit it, lined it up and tried pushing clip in - didn't push too hard and the clip broke into pieces and the section on the panel which it clips into appears to have broken too - brittle plastic?
Had a search on the internet and nothing obvious comes up for a replacement. Nothing on monkfish site when I checked earlier either. Anybody know where I can get a replacement from (panel and clips) or if there are other cars they can be sourced from - maybe a Vauxhall omega or something? Part numbers or "proper" manufacturer description would probably help too...
Thanks.
Photo's of whats broke or where it was would help certain members here help you...

If you mean the #2 bit in the attached link, it says discontinued. 
http://www.newgmparts.com/oem-part/pontiac/gto/200...
You might need to check compatibility if yours is a big boot car, as they weren't marketed as Pontiacs at that time. If it is the same, the part number will be 92059694

http://www.newgmparts.com/oem-part/pontiac/gto/200...
You might need to check compatibility if yours is a big boot car, as they weren't marketed as Pontiacs at that time. If it is the same, the part number will be 92059694
Wyld Stallyn said:
Have you tried the Talcum Powder Method to track down the Leak?
Photo's of whats broke or where it was would help certain members here help you...
Nope, not tried that yet - but it's wetest around the fuel cap cover release lever and rear passenger footwell. That's probably due to the car generally being parked nose up on a slightly sloping drive.Photo's of whats broke or where it was would help certain members here help you...

I'll sort out a picture later - probably won't need refitting until after I've checked out behind the door card anyway.

ARAF said:
If you mean the #2 bit in the attached link, it says discontinued. 
http://www.newgmparts.com/oem-part/pontiac/gto/200...
You might need to check compatibility if yours is a big boot car, as they weren't marketed as Pontiacs at that time. If it is the same, the part number will be 92059694
That looks to be a section of the outer mirror housing/support bracket. 
http://www.newgmparts.com/oem-part/pontiac/gto/200...
You might need to check compatibility if yours is a big boot car, as they weren't marketed as Pontiacs at that time. If it is the same, the part number will be 92059694
I actually mean the black plastic cover on the inside of the door that is up by the mirror - just a cover and an air vent/guide.
The defroster grill and gasket? (#10 & 11)
http://www.newgmparts.com/oem-part/pontiac/gto/200...
If it doesn't look like this, then I guess the Pontiac is different.
http://www.newgmparts.com/oem-part/pontiac/gto/200...
If it doesn't look like this, then I guess the Pontiac is different.
KMud said:
I broke the white pin that holds that sail-piece on. Bit chintzy that. I'd talk to Raving/Brett.
That sounds like it. Its the small separate triangular plastic piece on the inside of the door by the mirror. In first pic on this page it's pretty much top centre...?
http://www.highperformancepontiac.com/editorial/hp...
I have broken one of them too. The clips might be similar to standard ones available at any parts store.
"mirror inner cover cap" is what it is called in the service manual.
I think you can put this part on the car before you put the door trim on the door. Or you can remove the whole door trim without removing this part if that makes sense. I am also not sure if a standard Holden Commodore one will fit as I know the doors are longer??? on a Monaro and the door frame might be raked back a bit more???
"mirror inner cover cap" is what it is called in the service manual.
I think you can put this part on the car before you put the door trim on the door. Or you can remove the whole door trim without removing this part if that makes sense. I am also not sure if a standard Holden Commodore one will fit as I know the doors are longer??? on a Monaro and the door frame might be raked back a bit more???
Since it wasn't actually raining today (for once!!) set to taking the door card off.
Unfortunately you have to lift the door card up a bit to get it over the top lip so you would have to remove that "mirror cover" piece anyway.
Anyhow - checked the seal/gunk around the edges of the plastic sheet and looked ok. A couple of tares around where some of the mechanisms rods and cables come through, so covered those is some duct tape while I was there.
Then when I went to refit spotted something - there are 4 screw holes on the bottom edge of the door below the plastic sheet, yet the lower edge of the door card only has three holes? The end one nearest outside edge of the door appeared to be unused, as there was no thread marks in it - and it was open. I think what's been happening is that as I have the car back end down when there's been the heavy rain, water has been building up in the bottom of the door and due to the slant has been collecting more to the rear, and not draining fast enough - so ends up coming out the unused screw hole? Just a theory anyway... window seal should stop water get in in the first place anyway I think?
Sealed it with a layer of duct tape, then a screw, then more duct tape on top as a temp fix for now. Also spotted that the other used screw holes look like somebody has tried applying some silicon in there.
I think the long term fix would be to use a couple of small rubber washers to seal the screw hole up properly, as well as maybe new door/window seals. Hopefully the thread will last being taken off again.
I may be able to get away with just a new clip for the mirror plastic panel piece, even if the clip holder section looks a bit damaged. Doesn't need to be too tight a fit anyway, just not fall off when you open the door.
Unfortunately you have to lift the door card up a bit to get it over the top lip so you would have to remove that "mirror cover" piece anyway.
Anyhow - checked the seal/gunk around the edges of the plastic sheet and looked ok. A couple of tares around where some of the mechanisms rods and cables come through, so covered those is some duct tape while I was there.
Then when I went to refit spotted something - there are 4 screw holes on the bottom edge of the door below the plastic sheet, yet the lower edge of the door card only has three holes? The end one nearest outside edge of the door appeared to be unused, as there was no thread marks in it - and it was open. I think what's been happening is that as I have the car back end down when there's been the heavy rain, water has been building up in the bottom of the door and due to the slant has been collecting more to the rear, and not draining fast enough - so ends up coming out the unused screw hole? Just a theory anyway... window seal should stop water get in in the first place anyway I think?
Sealed it with a layer of duct tape, then a screw, then more duct tape on top as a temp fix for now. Also spotted that the other used screw holes look like somebody has tried applying some silicon in there.
I think the long term fix would be to use a couple of small rubber washers to seal the screw hole up properly, as well as maybe new door/window seals. Hopefully the thread will last being taken off again.

I may be able to get away with just a new clip for the mirror plastic panel piece, even if the clip holder section looks a bit damaged. Doesn't need to be too tight a fit anyway, just not fall off when you open the door.

ARAF said:
There should be drain holes in the bottom of the door (towards the outer skin). Check that these are clear, then the water shouldn't ever get as high as the hole you have just filled.
We have had a bit of rain just lately though, haven't we.
I'll check the drain holes - but there isn't any water in there at the moment so must be draining at least some. There have been some seriously heavy rain storms last few weeks with driving winds - so may just have been too much for it given it's an australian car. We have had a bit of rain just lately though, haven't we.


Will have to try drying out the carpet completely then see if it still gets wet. Shame I haven't got a hair dryer.

Thanks for the link. I'm getting wet carpet by the petrol cover release lever too, as well as in the driver side rear passenger footwell.
Took some pics myself. First pic shows the four bottom screw holes below the plastic on mine - even seems to have cutouts in the plastic for them as well. Normal inside drain holes are clear - but that would just let water collecting behind the plastic sheet to go into the bottom of the door. As somebody pointed out (on the other thread I think?) may as well just tuck the plastic in at the bottom.

Here you can see the unused screw hole, which is below the drain points. If the car is slopping rear end down this is the lowest of the screw holes too - and open.

In the last pic you can see my quick diy mod (to get it back together before the rain comes again!) where I used a spare screw and some duck tape to seal the unused hole. You can also see the normal drain grommet on the bottom right too. Given the door is narrow down there it's probably easier to flow out the screw hole if there is any substantial water in there, or just can't flow out fast enough. Will check to make sure it's not blocked though.

Think I'm just a victim of potentially worn door seals and some particularly heavy rain.
Took some pics myself. First pic shows the four bottom screw holes below the plastic on mine - even seems to have cutouts in the plastic for them as well. Normal inside drain holes are clear - but that would just let water collecting behind the plastic sheet to go into the bottom of the door. As somebody pointed out (on the other thread I think?) may as well just tuck the plastic in at the bottom.


Here you can see the unused screw hole, which is below the drain points. If the car is slopping rear end down this is the lowest of the screw holes too - and open.

In the last pic you can see my quick diy mod (to get it back together before the rain comes again!) where I used a spare screw and some duck tape to seal the unused hole. You can also see the normal drain grommet on the bottom right too. Given the door is narrow down there it's probably easier to flow out the screw hole if there is any substantial water in there, or just can't flow out fast enough. Will check to make sure it's not blocked though.

Think I'm just a victim of potentially worn door seals and some particularly heavy rain.
EssexVXR8 said:
No your not looking at the right drain holes, should be some on the bottom door skin return 
Oops!! Yeah - erm, those ones look ok. I'm a tall guy and it takes effort to get that low. 

They are fine, clear and pretty big - way bigger than piddly screw holes, so all my previous work was probably in vain. Ahh well.
Will see if problem persists and see if there's another cause then.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff


