Roller rockers
Discussion
Are they worth it??
Looking at these
http://www.ebay.co.uk/itm/Chevy-LS1-Alloy-Roller-R...
Seem cheap if they give you a few extra BHP
Looking at these
http://www.ebay.co.uk/itm/Chevy-LS1-Alloy-Roller-R...
Seem cheap if they give you a few extra BHP
neal1980 said:
That's not what I'm reading.
They look pretty though
I have yella terras and I'm damn sure they don't give any extra HP. You would use them to beef up the valve train after some HP mods to your motor. Consensus is that stock rockers are hard to beat and benefit from a trunion upgrade as G has said.They look pretty though

S800VXR said:
After reading this thread I went and did some reading.... Looks like a worthwhile safety mod to swap out for upgraded rockers?
Not so much.Whilst I use YT's myself and havent had problems, the same cannot be said for all. Whether it was a bad batch for a few years or whether it's a more common problem, there have been a lot of failures.
For that reason alone I wouldnt buy another set. And those "Granatelli" look identical to YT's in every respect. They probably just change the packaging.
An awful lot of people do say just use the standard rockers with the trunion upgrade. Lots and lots, so it would seen an easy option.
If using more lift and you wanted roller rockers, then...f
k knows lol.Comp's designs have varied over the years, Some people seem to like Crane. Jesel always get good reviews although not sure if they offer cheaper sets.
Some aftermarket heads can be fussy about which rockers you use too
S800VXR said:
After reading this thread I went and did some reading.... Looks like a worthwhile safety mod to swap out for upgraded rockers?
What are you worried about failing? The stock rockers don't really fail often from what I've read, but they are sub-optimal in terms of scrubbing the valve tips and applying side loads that do in bronze valve guides in aftermarket heads. The needle bearings on the stock rockers are a liability though, hence the trunion upgrade. I went for a light-ish valve-train (not as light as Gurmeet's Ti bits
) with beehive springs. Many go for dual springs and roller rockers.Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff


