EML on after decat
Author
Discussion

fastbikes76

Original Poster:

2,450 posts

153 months

Tuesday 29th April 2014
quotequote all
So yeah, That went well laugh

I gutted a spare set of stock cats and the results were pretty good. Car feels much crisper, throttle response is good, noise level increased slightly and now get nice little pops on upshifts.

The down side is today after around a 100 miles the engine light came on. Pulled the codes and its cat sensor threshold exceeded on both sensors, prior to this we've had no codes ever.

What do others do when fitting decats to avoid EML's ?? I'm guessing just an O2 spacer and job done.

Cheers
Elton
cool

Edited by fastbikes76 on Tuesday 29th April 22:01

KMud

2,924 posts

187 months

Tuesday 29th April 2014
quotequote all
Is this a Monaro with O2s pre- and post- cat?

fastbikes76

Original Poster:

2,450 posts

153 months

Tuesday 29th April 2014
quotequote all
KMud said:
Is this a Monaro with O2s pre- and post- cat?
Sorry..had a brain fart and didn't say laugh

Its a LS2 VXR8

I don't remember seeing post cat sensors but then I wasn't looking for them either biglaugh

ARAF

20,759 posts

254 months

Tuesday 29th April 2014
quotequote all
fastbikes76 said:
KMud said:
Is this a Monaro with O2s pre- and post- cat?
Sorry..had a brain fart and didn't say laugh

Its a LS2 VXR8

I don't remember seeing post cat sensors but then I wasn't looking for them either biglaugh
I'm sure they do, as that was one reason for not mounting our cutouts just after the cats, on our old VXR8

fastbikes76

Original Poster:

2,450 posts

153 months

Tuesday 29th April 2014
quotequote all
ARAF said:
I'm sure they do, as that was one reason for not mounting our cutouts just after the cats, on our old VXR8
Will have a looky tomorrow. If it has post cat sensors I will just fit some O2 spacers and be done.

smile

ARAF

20,759 posts

254 months

Tuesday 29th April 2014
quotequote all
Here you go. You can see the blue wires. smile

rich24v said:
Evening all,
From cat back, did the LS3 share the same exhaust as LS2 ?

This is my LS3

D_G

1,958 posts

240 months

Tuesday 29th April 2014
quotequote all
Or buy two emulators.

fastbikes76

Original Poster:

2,450 posts

153 months

Tuesday 29th April 2014
quotequote all
sorted...2 new post cat sensor spacers on order.

cool

MyM8V8

9,468 posts

226 months

Wednesday 30th April 2014
quotequote all
Or just omit the Mils in the tune. Cost you a bit to do that though. £85 for the license and then some kind person with efilive.

neiljohnson

11,298 posts

238 months

Wednesday 30th April 2014
quotequote all
Something like p0420 cat efficiency threshold?

All post 2000 cars had to have a second sensor to moniter cat performance

Not sure if spacers will work on these tbh but worth a try
The only way of correctly doing it is like Gareth said & omit the sensors in the tune

Tyre Smoke

23,018 posts

292 months

Wednesday 30th April 2014
quotequote all
Have a similar problem with my Range Rover Sport. Did a bit of research and this 'might' be an option....[snippetty snip]....

Assuming you do want a DC voltage, then the correct way to do this is a resistor, a zener diode and a trim pot (variable resistor). A 560ohm 1/2w resistor from the nominal 12v supply connected to a 1.5v zener diode which is then connected to the ground side. A 500ohm trim pot is then connected across the zener diode and the output voltage taken from the centre of the trim pot and ground. The pot can then be adjusted to give a suitable output between 0 and 1.5v

Which is basically used to fool your post cat sensor into thinking all is tickety boo wit the emissions. I have all the bits a bobs from Ebay for less than a fiver, but have yet to find the time to try it.




SturdyHSV

10,443 posts

198 months

Wednesday 30th April 2014
quotequote all
MyM8V8 said:
Or just omit the Mils in the tune. Cost you a bit to do that though. £85 for the license and then some kind person with efilive.
Is it only £85 for a licence to tune another engine?!

I can see I'm going to be popular with some friends very shortly... hehe

KMud

2,924 posts

187 months

Wednesday 30th April 2014
quotequote all
SturdyHSV said:
Is it only £85 for a licence to tune another engine?!

I can see I'm going to be popular with some friends very shortly... hehe
Yes, but did you only get the one license with your flashscan? I believe I have two.

SturdyHSV

10,443 posts

198 months

Wednesday 30th April 2014
quotequote all
KMud said:
Yes, but did you only get the one license with your flashscan? I believe I have two.
I believe you get one engine and one tranny (so to speak)? May have to check with ringram

MyM8V8

9,468 posts

226 months

Wednesday 30th April 2014
quotequote all
SturdyHSV said:
MyM8V8 said:
Or just omit the Mils in the tune. Cost you a bit to do that though. £85 for the license and then some kind person with efilive.
Is it only £85 for a licence to tune another engine?!

I can see I'm going to be popular with some friends very shortly... hehe
Yes and the beauty of it is once you have the license on the V2, you can reflash with Efilive as many times as you want. (You cant with HPT and it cost credits every time IIRC.) Disdavantage to your mates (and you I suppose) is that they keep having to come back to you.