My Paddle Shifter Mod
Discussion
Not connected up yet but paddles all fitted and well on the way. Spent allot of time getting the fit factory looking as didn't want anything Heath Robinson in there. Wish I'd done this before we went away as driving through the Stelvio and Davos passes would have been allot easier last week with these fitted.
Full details once it's up and running.





Full details once it's up and running.

Tattooboy said:
"A lot easier" ?????? Is is difficult finding D ???? 
Looks good, hope it wires up easy and works how you you want it to.
Yea I know what your saying but driving up small alpine roads or running on the motorway are much better in Tip mode as you can hold the gear and use the SC torque to fire up the road rather than it chopping down and going ballistic all the time.
Looks good, hope it wires up easy and works how you you want it to.
ARAF said:

It looks like a nice and tidy job, so well done. From my experiences, I'm not sure how much use they will get though, as I found that using the gearbox properly pushed engine oil temps too high.
Z0m81e said:
Does anyone know technically how these work I had an idea I wanted to try with an arduino but thus far in my short investigation I haven't worked out how to manipulate the gear shift?
I think you wire them through the wheel, down through the console and tap them into the +/- shifter.So to use them you push the shifter left, and then the paddles work.
This is assuming that it's done the same way as the guys on the Pontiac G8 forums.
Defo interested in this. Can you give us a list of part numbers? Unfortunately I'm not as local as some of you.
Bibbs said:
I think you wire them through the wheel, down through the console and tap them into the +/- shifter.
So to use them you push the shifter left, and then the paddles work.
This is assuming that it's done the same way as the guys on the Pontiac G8 forums.
Defo interested in this. Can you give us a list of part numbers? Unfortunately I'm not as local as some of you.
You're local to me Bibbs!So to use them you push the shifter left, and then the paddles work.
This is assuming that it's done the same way as the guys on the Pontiac G8 forums.
Defo interested in this. Can you give us a list of part numbers? Unfortunately I'm not as local as some of you.

Stef
Bibbs said:
S800VXR said:
Bibbs said:
Just to bump this. The MY15 HSVs have paddles.
So I'll be popping down the local dealer and getting some part numbers.
The Insignia VXR auto has paddles too so worth checking that out.Think they are plastic though...So I'll be popping down the local dealer and getting some part numbers.
Sometimes we forget there are people on here that actually live in the country where our cars are made.FYI, some Holdens are also getting paddles for 2015, so they may be cheaper there, than from an HSV dealer.

Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff




