Wallet just took a beating...

[Yanayaya]

My Monaro parts orders arrived from the fish today. Super happy and super skint now haha.

VCM Induction unit and Pedders Extreme xA Coilovers

[Yanayaya]

Any advice on fitting that heat shield would be appreciated. The holes don't seem to line up with anything...It's late though and low light so I've not had a massive amount of time to take a good look.

[VinceM]

You need to place the shield in situ and mark the holes then drill them. Use self tappers to make hole to secure. It's a bit awkward but once all together it's snug and fits good.

[Yanayaya]

VinceM said:

You need to place the shield in situ and mark the holes then drill them. Use self tappers to make hole to secure. It's a bit awkward but once all together it's snug and fits good.

I'll be hones, I was worried you were going to say that. I hate drilling into a car panel.

[Mud_]

I'd be tempted to use rivnuts or rubber well nuts.

[Yanayaya]

Mud_ said:

I'd be tempted to use rivnuts or rubber well nuts.

A good shout tbh. Might save this job for the weekend and do it right.