Jacking up on hydraulic jacks
Jacking up on hydraulic jacks
Author
Discussion

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
What is the best place to jack up the ro's I want to change the oil and filter and check other stuf under the car, I want to use two hyd trolly type jacks, putting it where the normal jack goes, does not look strong enough and a wierd shape.

GreenV8S

31,027 posts

315 months

Saturday 31st October 2009
quotequote all
If in doubt, a pair of ramps would be a safer alternative if you aren't planning to take the wheels off.

Yertis

19,741 posts

297 months

Saturday 31st October 2009
quotequote all
GreenV8S said:
If in doubt, a pair of ramps would be a safer alternative if you aren't planning to take the wheels off.
I don't think doubt even comes into it - NEVER get under a car supported by trolley jacks. Ramps or axle stands, and for a Monaro pretty substantial axle stands too.

Sorry to sound like a grumpy old git but you don't want to get squashed.

mfp4073

2,111 posts

205 months

Saturday 31st October 2009
quotequote all
Very topical..I bent the front passenger side box section (the bit with the holes in ) just last week.I tried to sort it out but without success, therefore as its going back to vauxhall for some unrelated work next week Im going to ask them to fix it...I hope.
My best advice use a block of flat wood on the jack, then use the main chassis rail to lift the car, and be carefull, i've been a right miserable git since I damaged it!

gsd2000

11,515 posts

214 months

Saturday 31st October 2009
quotequote all
mfp4073 said:
Very topical..I bent the front passenger side box section (the bit with the holes in ) just last week.I tried to sort it out but without success, therefore as its going back to vauxhall for some unrelated work next week Im going to ask them to fix it...I hope.
My best advice use a block of flat wood on the jack, then use the main chassis rail to lift the car, and be carefull, i've been a right miserable git since I damaged it!
Your not the only one, i've done this but i just don't think about it as i'm fairly certain that the bent bit is only cosmetic damage and not structural. But yeah i was annoyed with myself but knowing me i will most likely make it worse trying to make it better

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
I have never really liked ramps, you have to be sooooo carefull when getting up on them especially when you have a low car like the ro, I do have proper strong axle stands.

Has anyone else used ramps on their Ro if so, how long and how high are they, I do have some ramps but they seem to be quite steep, I am going out to see if they will even go under the front of the car, brb with photo biggrin

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all


My ramps hit the front bumper before the wheel is even near the ramp.

Drew SS

2,683 posts

215 months

Saturday 31st October 2009
quotequote all
draining the oil u really want it on level ground

GreenV8S

31,027 posts

315 months

Saturday 31st October 2009
quotequote all
snowwolf said:
My ramps hit the front bumper before the wheel is even near the ramp.
How far do you need to pick the car up before it will clear the ramp? It would probably only need a couple of inches so two bits of 2x4" and you're sorted. Failing that, low angle ramps are available. There's nothing wrong with jacking the car up when required as long as you do it safely, but if you aren't sure how to do it safely then driving it onto a pair of ramps will imo give you much less risk of damaging the car.

Drew SS

2,683 posts

215 months

Saturday 31st October 2009
quotequote all
i made a set for myself out of 2 x 6 timbers about a metre long one for each wheel then put another length on top but half the lenght so it went up on the first stage and the up on the second so the car was up on all four and u could get under no worries can post a pic if u want the idea

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
How high do you think you need to get the car up to be able to do the engine oil and filter?

Drew SS

2,683 posts

215 months

Saturday 31st October 2009
quotequote all
now that depends how big ur belly is im of to nightshift will post a pic in the mornin to give u some idea

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
well talkin of bellies, mine is not that small frown LOL yer be great to see pics

MyM8V8

9,468 posts

226 months

Saturday 31st October 2009
quotequote all
I'm lucky smile


snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
mmmmmmmm would love one of the lifts :-)

MyM8V8

9,468 posts

226 months

Saturday 31st October 2009
quotequote all
snowwolf said:
mmmmmmmm would love one of the lifts :-)
£1100 smackers brand new.

doleboy

747 posts

248 months

Saturday 31st October 2009
quotequote all
MyM8V8 said:
I'm lucky




You're not that lucky mate. Look your bumpers fallen off.


snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
MyM8V8 said:
snowwolf said:
mmmmmmmm would love one of the lifts :-)
£1100 smackers brand new.
That isnt that bad really, might look into getting one, just got to find somewhere to put it LOL

the muppet

669 posts

222 months

Saturday 31st October 2009
quotequote all
MyM8V8 said:
snowwolf said:
mmmmmmmm would love one of the lifts :-)
£1100 smackers brand new.
Or £350 second-hand....



Edited by the muppet on Saturday 31st October 20:20

snowwolf

Original Poster:

11,503 posts

206 months

Saturday 31st October 2009
quotequote all
mmmmmmmm you got one for sale?