VXR8 Bonnet vents
Discussion
Only had one real big issue with underbonnet temps, stuck in crawling traffic for 2.5 hours, killed HT leads and couldnt be good for everything else under the bonnet. Headers going to Zircotec for plasma sprayed ceramic coating, thought id do a belt and braces job. Also got a stone dent on bonnet line near where id put vents, so smart man could then access that.
ARAF said:
Before actually getting the bonnet vented, I'd be inclined to raise the bonnet at the scuttle by an inch or so (as a temporary measure), just to see if that cools things.
Whats your logic behind that then? This is a high pressure area on the car therefore only let more air into the bay and not let any out. Waste of time and looks shiiiite.Vez said:
ARAF said:
Before actually getting the bonnet vented, I'd be inclined to raise the bonnet at the scuttle by an inch or so (as a temporary measure), just to see if that cools things.
Whats your logic behind that then? This is a high pressure area on the car therefore only let more air into the bay and not let any out. Waste of time and looks shiiiite.ARAF said:
Vez said:
ARAF said:
Before actually getting the bonnet vented, I'd be inclined to raise the bonnet at the scuttle by an inch or so (as a temporary measure), just to see if that cools things.
Whats your logic behind that then? This is a high pressure area on the car therefore only let more air into the bay and not let any out. Waste of time and looks shiiiite.ARAF said:
Vez said:
ARAF said:
Before actually getting the bonnet vented, I'd be inclined to raise the bonnet at the scuttle by an inch or so (as a temporary measure), just to see if that cools things.
Whats your logic behind that then? This is a high pressure area on the car therefore only let more air into the bay and not let any out. Waste of time and looks shiiiite.Vez said:
ARAF said:
Vez said:
ARAF said:
Before actually getting the bonnet vented, I'd be inclined to raise the bonnet at the scuttle by an inch or so (as a temporary measure), just to see if that cools things.
Whats your logic behind that then? This is a high pressure area on the car therefore only let more air into the bay and not let any out. Waste of time and looks shiiiite.
I don't think I mentioned winning any beauty contest prizes. If the problem is heat build-up in the engine area when the car is stationary, then raising the trailing edge of the bonnet will allow hot air to escape, before you go to the expense of cutting holes in the bonnet.
It will hinder getting rid of heat when on the move though.
It will reduce airflow over the rad on the move at speed too.
rickf_uk said:
Has anyone here looked at wrapping their header pipes old muscle car style. I was speaking to a local tuner and he quite often does this Ultimas and Nobles to keep engine heat down when racing. He reckons on about £350 for the job on a 'Ro.
You can now get the headers ceramic dipped, for the same insulating effect. There is a downside, but I can't for the life of me remember what it is, at the moment. 
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff



now considering Focus RS as the angles are right for bonnet lines, fitted above the headers. What do you think!!!!!!!!

