Panel Alignment/Belly Pan
Panel Alignment/Belly Pan
Author
Discussion

Rum Runner

Original Poster:

2,349 posts

248 months

Thursday 8th April 2010
quotequote all
Please can somebody advise what this flap is for on the rear belly pan.


I am looking at buying this car.

Just wondered if its normal to find the drivers door out of alignment at both ends.


The bumper sagging off the front edge of the wing and the boot lid is well off to one side as well?. (Boot lid first pic)


The rest of the car looks very good and does not seem have suffered to much salty winter use as the underside and engine bay look good. (If I buy it first thing is a Waxoyle and marine corrosion guard the engine bay, seen to many shabby ones).


soco

227 posts

203 months

Thursday 8th April 2010
quotequote all
That flap is something to do with access to a fixture used to hold the car secure when it's being transported. It should be closed when you're driving around otherwise the foglamp gets clarted up and they're not cheap to replace.

Rum Runner

Original Poster:

2,349 posts

248 months

Thursday 8th April 2010
quotequote all
Looks to me like the car swerved a PDI.

Edited by Rum Runner on Thursday 8th April 01:08

SimonV8ster

13,035 posts

259 months

Thursday 8th April 2010
quotequote all
That diffs shiney !! All the ones i've seen are covered in surface rust !!

vxrandy

1,785 posts

214 months

Thursday 8th April 2010
quotequote all
My drivers door has dropped and also suffers from the sagging bumper which is quite common, there should be 2 plastic push rivit located under the reg plate housing part of the bumper,but they are usually missing. That dif does look very shiny though. These are not the best built cars but look past that and they are great and will make you grin every time you get in it biggrinthumbup

monkfish1

12,516 posts

255 months

Thursday 8th April 2010
quotequote all
All looks pretty normal to me!! The flap should be closed though. Usual PDI type issue.

Rum Runner

Original Poster:

2,349 posts

248 months

Thursday 8th April 2010
quotequote all
Yep it looks good on the underside/engine bay something that attracted me to the car, not see to much winter road action.
As said it will be straight in for a waxoyle and marine corrosion guard which we use on inboard and outboard motors.

well_fans

4,193 posts

255 months

Thursday 8th April 2010
quotequote all
anyone thats got even panel gaps all round has more to worry about because I've never seen one thats out the factory where they all line up evenly All seem built to that Friday afternoon standard we usually expect from UK car builders.

Wolfracer

2,074 posts

237 months

Thursday 8th April 2010
quotequote all
well_fans said:
anyone thats got even panel gaps all round has more to worry about because I've never seen one thats out the factory where they all line up evenly All seem built to that Friday afternoon standard we usually expect from UK car builders.


And look what happened there...



Back to OP, bumpers held on with little more than sheer will and determination so no wonder some drop - but you could just "manually" adjust it back with a good push!
Can't comment on panel gaps, but I've never noticed any massive issues and none have been reported on here on the last couple of years...

hsv_rulz

957 posts

253 months

Thursday 8th April 2010
quotequote all
vxrandy said:
My drivers door has dropped and also suffers from the sagging bumper which is quite common, there should be 2 plastic push rivit located under the reg plate housing part of the bumper,but they are usually missing. That dif does look very shiny though. These are not the best built cars but look past that and they are great and will make you grin every time you get in it thumbup


The 2 holes under the front reg plates that you mention are the mount points for Aussie reg plates, should be a white plastic fitting that accepts self tapping screws. You should find the same behind the rear plate.

Bonnie and Clyde

11,701 posts

223 months

Thursday 8th April 2010
quotequote all
Rum Runner said:
Please can somebody advise what this flap is for on the rear belly pan.
The open flap above is put into the open position during transit. It was then meant to be screwed closed. Ours was open when we first went to Monkfish. They shut it straight away.
The problem is that water off the road goes directly up through the flap and if not caught in time will corrode your rear fog light. And at £300 each thats not a good thing.

Every thing else looks normal to me

BTW if anyones said this already sorry for the repost redface

Rum Runner

Original Poster:

2,349 posts

248 months

Thursday 8th April 2010
quotequote all
£300 for a fog lamp !, better check that ...........hopefully given its low miles and good under-body condition it may not be to bad.
Is the fog lamp sealed or does all the road salt get into the lens and reflector, or does the outside of the reflector rot away?.



Edited by Rum Runner on Thursday 8th April 23:28

Bonnie and Clyde

11,701 posts

223 months

Friday 9th April 2010
quotequote all
Rum Runner said:
£300 for a fog lamp !, better check that ...........hopefully given its low miles and good under-body condition it may not be to bad.
Is the fog lamp sealed or does all the road salt get into the lens and reflector, or does the outside of the reflector rot away?.



Edited by Rum Runner on Thursday 8th April 23:28
Ours had about 10k on the clock when we got it. Monkfish closed the flap and all's been well. As long as you shut it and not run it around for years open i wouldn't worry
Not sure about what part rots but like i say close it and forget it

One of our front fogs stopped working and we thought it was going t be a whole unit but Roger (Monkfish) soldered some wiring and it was fine.
I dont know where in the country your based but its always worth booking in with a specialist to get it checked over. If you buy it of course

monkfish1

12,516 posts

255 months

Friday 9th April 2010
quotequote all
Rum Runner said:
£300 for a fog lamp !, better check that ...........hopefully given its low miles and good under-body condition it may not be to bad.
Is the fog lamp sealed or does all the road salt get into the lens and reflector, or does the outside of the reflector rot away?.



Edited by Rum Runner on Thursday 8th April 23:28


Yes, not cheap. On the upside, it is a revised design that is properly waterproof (unlike the original) and integrated into the reverse sensor harness.