which paint?
Author
Discussion

gsd2000

Original Poster:

11,515 posts

214 months

Thursday 8th April 2010
quotequote all
I have tried this in the general section with no reply so has anyone got any ideas?

I have a few jobs to do on my car and i was just wondering what the best paint for each job was. The jobs include

repaint my ap racing calipers red
paint the centre hub of my brake disks
repaint my rear speaker grills satin black
repaint my front wiper arms satin black
tidy up the paintwork on my front and rear subframes
i also have a set of bmw style 71 2 piece split rims that i am going to refurb what would be a suitable paint?
Also as i need to remove my gearbox to rebuild it so what would be a suitable paint?

I was thinking of using epoxy mastic 121 for the subframes but what should i use for everything else?

ferb

3,112 posts

241 months

Thursday 8th April 2010
quotequote all
gsd2000 said:
I have tried this in the general section with no reply so has anyone got any ideas?

I have a few jobs to do on my car and i was just wondering what the best paint for each job was. The jobs include

repaint my ap racing calipers red
paint the centre hub of my brake disks
repaint my rear speaker grills satin black
repaint my front wiper arms satin black
tidy up the paintwork on my front and rear subframes
i also have a set of bmw style 71 2 piece split rims that i am going to refurb what would be a suitable paint?
Also as i need to remove my gearbox to rebuild it so what would be a suitable paint?

I was thinking of using epoxy mastic 121 for the subframes but what should i use for everything else?

You know what I use hehe
For calipers I used caliper paint from Demon Tweeks. Has lasted 4 years and 6 track days thumbup (I mean lots of heat) Still perfec

gsd2000

Original Poster:

11,515 posts

214 months

Thursday 8th April 2010
quotequote all
I will have a look at the caliper paint thumbup

Bonnie and Clyde

11,701 posts

223 months

Thursday 8th April 2010
quotequote all
I dont know about you GSD but if i were you i'd go for a nice red alloy with a mirror polished face.
Just a thought








getmecoat

Well_Fans

4,193 posts

255 months

Friday 9th April 2010
quotequote all
I used high temp engine paint for hubs, seems to have lasted not too bad. Caliper paint I found was a bit too thin and needed several coats so last car I did I tried Smoothrite - not bad but took 3 bloody days to dry lol. Rear speaker grills I just bought ordinary aerosol from local motor parts store. 5 mins to paint - 3hrs to get out and put back as you have to strip the entire back of the car out.

Before


Inside of car to take them out


Finished article

monkfish1

12,516 posts

255 months

Friday 9th April 2010
quotequote all
Anything outside the car i would do with the same paint used on the bodywork. There isn't anything better.

behold81

2,931 posts

200 months

Friday 9th April 2010
quotequote all
If the part can be fully removed then get it powdercoated.